GE CBR-PB3-WD installation manual 11 PB3-POS with DVMRe -CD/CS Units, DVMRe-CS/CD Setup

11PB3-POS with DVMRe -CD/CS Units

If the unit to be connected to the PB3 is a DVMRe-CD (Duplex) or a DVMRe-CS (Simplex) unit, please note the following changes to the normal installation and configuration process below.

NOTE

Kalatel recommends using a DVMRe-CT (Triplex) unit to initially connect the PB3 unit to. The on-screen text display will make it easy to confirm successful capture of POS transactions. Once you have confirmed proper operation, disconnect the Triplex unit and hook-up the Duplex (or Simplex) unit as indicated below. Alternatively, you can confirm configuration using a Laptop/PC running Windows HyperTerminal.

11.1 DVMRe-CS/CD Setup

Follow the installation steps in Section 5.1 through step number 8:

Connecting the PB3 to a DVMRe-CS/CD:

The PB3 connects to either RS-232/1 or RS-232/2 port of the DVMRe- CD/CS depending on if a modem is installed on RS-232/1 port.

a.NO MODEM

i.ProBridge Port #1 (RJ45) connects to RS-232/1 Port of the DVMRe-CD/CS using the supplied RJ45 to DB9F cable.

ii.The DVMRe communications port needs to be programmed as follows:

Communications>RS-232>Port 1 > ATM Activate

b.MODEM (Connected to RS-232/1 Port of DVMRe-CD/CS)

i.ProBridge Port #1 (RJ45) connects to RS-232/2 Port of the DVMRe-CD/CS using a RJ45 to DB9M cable. The provided RJ45 to DB9F cable can be used provided a

Kalatel CBR-PB3-WD 31 0150-0261A