GE GEK-106465A instruction manual Settings relative to Outputs, Output Logic

Page 36

I/O MODULES DESCRIPTION

Settings relative to Outputs:

Output Logic_0X _XX: Type of logic applied to outputs. Possible values are positive and negative. The default value is positive.

Output Type_0X _XX: Type of output adjusted. Possible values are normal, latched or pulse; the default value is Normal.

Pulse Output Time_0X _XX: This is the output pulse length in case the output type is selected to be pulse; the default value is 10000 ms.

Output Logic: Type of logic applied to outputs; possible values are Positive and Negative; the default value is Positive. Depending on the type of setting selected, the physical output will be in the same direction (positive) or opposite (negative) the output activation command.

Output Type: This is the set output type. Possible values are normal, latched or pulse; the default value is Normal. Normal type follows the activation command. Pulse type delays the time, according the Pulse Output Time setting. Latched type remains active after the activation command. The physical output reset when it is configured as latched can be performed using a deactivation command. Such command must be configured at Setpoint > Relay Configuration > Outputs > Contact Output Reset”.

Pulse Output Time: This is the output pulse length, applicable only to signals set as pulse type; the default value is 10000 ms and the setting range is 0 to 60000 ms (1 minute).

FIGURE 5-3 shows the types of signals associated to the different output configuration types.

FIGURE 5-3 OUTPUT LOGIC.

GEK-106465A

CIO Remote CAN Digital I/O Module

35

Page 35 Page 37
Image 36
Page 35 Page 37
Contents
CIO Table of Contents INPUT/OUTPUT Modules Description Circuit Continuity Supervision InputsImportant Procedures CIO Front ViewInspection Checklist Identification Label A4454P5EUROPE, Middle East and Africa GE Multilin AMERICA, Asia and Australia GE MultilinSafety Instructions Overview Introduction to F650 and F600 Family of RelaysHardware Architecture Software ArchitectureCommunications Architecture Summary of Features Product DescriptionOrdering Code CIO DescriptionTechnical Specifications Packaging and Weight Type TestsCategory Standard Class Test ApprovalsPower supply Input/Output module Module DescriptionMechanical Description MountingRear Panel Mounting Rear Cover Description Wiring External ConnectionsWiring Diagram for Model CIOH1J1 226B5113F2 Boards Board OptionMixed Termina Inputs Supervision OutputsOperand Description SUPCOIL2Without Supervision With Current Supervision with SEAL-IN With Simple Voltage Supervision Internal State Circuit Output Breaker Operand StatusHardware Hardware With Double Voltage Supervision 52/a 52/b Status of Involved Elements Inputs to F650Operand Contact INPUT0015 SUPCOIL2 Front Indicators SoftwareUser Interfaces Circuit Supervision and Contact SEAL-IN Circuits Circuit SupervisionContact SEAL-IN Control Settings for INPUTS/OUTPUTS INPUT/OUTPUT Boards SettingsGeneral Board Settings Settings relative to Inputs Input LogicSettings relative to Outputs Output LogicInput activation signals Contact Inputs INPUTS/OUTPUTS StatusInput Status Mixed Board Supervision Board Board F, G, H, J TypeContact Outputs activation signals Contact Output Activation Signals Contact Output OperatesContact Output Status Board F, G, H, JContact Output Reset Signals Contact Output Resets Contact Output ResetsIO Board Status Board StatusGeneral Considerations on the Power Supply Network Visual InspectionIndicators Power Suply TestingIsolation Tests Source OptionSettings/Control Elements/Inputs Outputs/Board Communication with the Master UnitInputs and Outputs Digital InputsContact Outputs Circuit Continuity Supervision InputsCoil Latching Circuits
Top Page Image Contents