Gefen ext-dvikvm-lan user manual Receiver Unit Layout

Page 15

Getting Started

Receiver Unit Layout

Back

1

2

3

4

5

ID

1

2

3

4

4

Name	Description
DVI Out	Connect a DVI cable from this connector to
	the DVI display.
RS-232	Connect the included RS-232 cable from this
	port to an RS-232 device.
	See Using RS-232for details.
LAN	Connects the Receiver unit to the network (or
	directly to the Sender unit) using an Ethernet
	cable. See the next page for installation
	instructions.
IR Ext	Connect an IR Extender cable
	(Gefen part no. EXT-RMT-EXTIRC or
	EXT-RMT-EXTIRN) to this port.
5V DC	Connect the included 5V DC locking power
	supply to this power receptacle.

page 5

Image 15

Contents 3GSDIDVI KVM General Safety Information Important Safety InstructionsProduct Registration Warranty InformationImportant Notice Contacting Gefen Technical SupportOperating Notes Operating Notes Features and Packing List FeaturesPacking List Table of Contents Appendix Page DVI Front Sender Unit LayoutSender Unit Layout BackReceiver Unit Layout Receiver Unit Layout Using a Direct Connection InstallationInstallation Local Area Network LAN Connection Getting Started RS-232 Supplementary ConnectionsIR Emitter Sample Wiring DiagramPage Operating DVI KVM over IP Displaying the IP Address Basic OperationRemote IP = Sender unit Basic OperationOperating the DVI KVM over IP Setting the IP Mode Setting the Video Channel Enabling or Disabling Video over IP Unicast and Multicast Modes Configuring Unicast ModeUnicast and Multicast Modes Unicast mode Receiver unit R1 is connected to Sender unit S2 Switching between Sender units in Unicast modeOperating the DVI KVM over IP Operating the DVI KVM over IP Configuring Multicast Mode Operating the DVI KVM over IP Basic RS-232 connection Using RS-232Using RS-232 RS-232 under Multicast Mode RS-232 under Unicast ModeUSB Control USB under Unicast ModeUSB Control Configuring Multicast Mode if necessary USB under Multicast Mode10 Receiver unit R2 currently has USB control Assigning USB control under Active per request mode Active on link mode Edid Management Using the Internal DVI EdidEdid Management Using the Downstream EdidConnect to microphone Audio ConnectionsConnect to computer speakers Audio ConnectionsUsing Hdmi Sources Video Mode Setting the Video ModePerforming a Factory Reset Sender UnitReceiver Unit Page Appendix Upgrading the Firmware Upgrading thePageFirmwarTitle XX denotes the number of maximum channels Channels or LessAppendix Inp Developer Notes3 4 5 6 7 Network Cable DiagramRack Tray Installation Specifications Specifications Page This product uses UL or CE listed power supplies