Gefen ext-dvikvm-lan user manual Using Hdmi Sources

Page 50

Operating the DVI KVM over IP

Audio Connections

Figure 2.13 - The Mic In jack, on all Receiver units, is automatically disabled in multicast mode.

Microphone

Powered speakers

Mic In

Receiver unit

 

Powered speakers

Receiver unit

 

 

Line Out

 

LAN

2

 

R

Sender unit

 

Line Out

R1

07

07

 

3

 

S

Sender unit

 

 

DVI In

2

09

S

 

Sender unit

S1

05

 

Line Out

07

Line In

 

Computer

DVI In

 

Using HDMI Sources

Hi-Def (HDMI) sources can be connected to the DVI KVM over IP when using HDMI-to-DVI adapters on the Sender and Receiver units. HDMI audio is passed through to the DVI Out port on the Receiver unit. The DVI KVM over IP will not pass content from HDCP sources such as Blu-ray players and Playstation® console systems.

If a 3.5mm mini-stereo cable is connected to the Line In jack on the Sender unit, then the HDMI audio will be disabled on the Receiver unit. The Line Out jack, on the Receiver unit, will output audio from the source connected to the Line In jack on the Sender unit.

HDMI audio cannot be output using the Line Out jack on the Receiver unit.

page 40

Image 50
Contents 3GSDIDVI KVM Important Safety Instructions General Safety InformationWarranty Information Product RegistrationContacting Gefen Technical Support Important NoticeOperating Notes Operating Notes Packing List Features and Packing ListFeatures Table of Contents Appendix Page DVI Sender Unit Layout FrontBack Sender Unit LayoutReceiver Unit Layout Receiver Unit Layout Installation Using a Direct ConnectionInstallation Local Area Network LAN Connection Getting Started Supplementary Connections RS-232Sample Wiring Diagram IR EmitterPage Operating DVI KVM over IP Basic Operation Displaying the IP AddressBasic Operation Remote IP = Sender unitOperating the DVI KVM over IP Setting the IP Mode Setting the Video Channel Enabling or Disabling Video over IP Configuring Unicast Mode Unicast and Multicast ModesUnicast and Multicast Modes Switching between Sender units in Unicast mode Unicast mode Receiver unit R1 is connected to Sender unit S2Operating the DVI KVM over IP Operating the DVI KVM over IP Configuring Multicast Mode Operating the DVI KVM over IP Using RS-232 Basic RS-232 connectionUsing RS-232 RS-232 under Unicast Mode RS-232 under Multicast ModeUSB under Unicast Mode USB ControlUSB Control USB under Multicast Mode Configuring Multicast Mode if necessary10 Receiver unit R2 currently has USB control Assigning USB control under Active per request mode Active on link mode Using the Internal DVI Edid Edid ManagementUsing the Downstream Edid Edid ManagementAudio Connections Connect to microphoneAudio Connections Connect to computer speakersUsing Hdmi Sources Setting the Video Mode Video ModeReceiver Unit Performing a Factory ResetSender Unit Page Appendix Upgrading the Firmware Upgrading thePageFirmwarTitle Channels or Less XX denotes the number of maximum channelsAppendix Developer Notes InpNetwork Cable Diagram 3 4 5 6 7Rack Tray Installation Specifications Specifications Page This product uses UL or CE listed power supplies