Gefen ext-dvikvm-lan user manual Basic Operation, Displaying the IP Address

Page 24

Operating the DVI KVM over IP

Basic Operation

Displaying the IP Address

If the IP address(es) of a Sender and/or Receiver unit are not known, then use the following procedure to display the IP address of any Sender or Receiver unit on the network.

1.Press and release the Switch button on the front panel of the Receiver unit. The current video channel will be displayed in the top-left corner of the screen.

Press the Switch button

Channel: 00

In the example, above, the current video channel is set to 0.

2.Change the video channel number by pressing and releasing the Switch button to advance to the next video channel. Video channel numbers range from 0 to 255. Consecutively pressing the Switch button will cycle through all 256 channels.

page 14

Image 24

Contents 3GSDIDVI KVM Important Safety Instructions General Safety InformationWarranty Information Product RegistrationContacting Gefen Technical Support Important NoticeOperating Notes Operating Notes Features and Packing List FeaturesPacking List Table of Contents Appendix Page DVI Sender Unit Layout FrontBack Sender Unit LayoutReceiver Unit Layout Receiver Unit Layout Installation Using a Direct ConnectionInstallation Local Area Network LAN Connection Getting Started Supplementary Connections RS-232Sample Wiring Diagram IR EmitterPage Operating DVI KVM over IP Basic Operation Displaying the IP AddressBasic Operation Remote IP = Sender unitOperating the DVI KVM over IP Setting the IP Mode Setting the Video Channel Enabling or Disabling Video over IP Configuring Unicast Mode Unicast and Multicast ModesUnicast and Multicast Modes Switching between Sender units in Unicast mode Unicast mode Receiver unit R1 is connected to Sender unit S2Operating the DVI KVM over IP Operating the DVI KVM over IP Configuring Multicast Mode Operating the DVI KVM over IP Using RS-232 Basic RS-232 connectionUsing RS-232 RS-232 under Unicast Mode RS-232 under Multicast ModeUSB under Unicast Mode USB ControlUSB Control USB under Multicast Mode Configuring Multicast Mode if necessary10 Receiver unit R2 currently has USB control Assigning USB control under Active per request mode Active on link mode Using the Internal DVI Edid Edid ManagementUsing the Downstream Edid Edid ManagementAudio Connections Connect to microphoneAudio Connections Connect to computer speakersUsing Hdmi Sources Setting the Video Mode Video ModePerforming a Factory Reset Sender UnitReceiver Unit Page Appendix Upgrading the Firmware Upgrading thePageFirmwarTitle Channels or Less XX denotes the number of maximum channelsAppendix Developer Notes InpNetwork Cable Diagram 3 4 5 6 7Rack Tray Installation Specifications Specifications Page This product uses UL or CE listed power supplies