Gefen ext-dvikvm-lan user manual Operating DVI KVM over IP

Page 23

DVI

KVM

Over

IP

02	Operating the
	DVI KVM over IP
	Basic Operation	14
	Displaying the IP Address	14
	Setting the IP Mode	17
	Setting the Video Channel	18
	Enabling or Disabling Video over IP	19
	Unicast and Multicast Modes	20
	Configuring Unicast Mode	20
	Switching between Sender units in Unicast mode	22
	Configuring Multicast Mode	25
	Using RS-232	27
	RS-232 under Unicast Mode	29
	RS-232 under Multicast Mode	29
	USB Control	30
	USB under Unicast Mode	30
	USB under Multicast Mode	32
	EDID Management	36
	Using the Internal DVI EDID	36
	Using the Downstream EDID	37
	Audio Connections	38
	Using HDMI Sources	40
	Setting the Video Mode	41
	Performing a Factory Reset	42
	Sender Unit	42
	Receiver Unit	42

Image 23

Contents 3GSDIDVI KVM General Safety Information Important Safety InstructionsProduct Registration Warranty InformationImportant Notice Contacting Gefen Technical SupportOperating Notes Operating Notes Packing List Features and Packing ListFeatures Table of Contents Appendix Page DVI Front Sender Unit LayoutSender Unit Layout BackReceiver Unit Layout Receiver Unit Layout Using a Direct Connection InstallationInstallation Local Area Network LAN Connection Getting Started RS-232 Supplementary ConnectionsIR Emitter Sample Wiring DiagramPage Operating DVI KVM over IP Displaying the IP Address Basic OperationRemote IP = Sender unit Basic OperationOperating the DVI KVM over IP Setting the IP Mode Setting the Video Channel Enabling or Disabling Video over IP Unicast and Multicast Modes Configuring Unicast ModeUnicast and Multicast Modes Unicast mode Receiver unit R1 is connected to Sender unit S2 Switching between Sender units in Unicast modeOperating the DVI KVM over IP Operating the DVI KVM over IP Configuring Multicast Mode Operating the DVI KVM over IP Basic RS-232 connection Using RS-232Using RS-232 RS-232 under Multicast Mode RS-232 under Unicast ModeUSB Control USB under Unicast ModeUSB Control Configuring Multicast Mode if necessary USB under Multicast Mode10 Receiver unit R2 currently has USB control Assigning USB control under Active per request mode Active on link mode Edid Management Using the Internal DVI EdidEdid Management Using the Downstream EdidConnect to microphone Audio ConnectionsConnect to computer speakers Audio ConnectionsUsing Hdmi Sources Video Mode Setting the Video ModeReceiver Unit Performing a Factory ResetSender Unit Page Appendix Upgrading the Firmware Upgrading thePageFirmwarTitle XX denotes the number of maximum channels Channels or LessAppendix Inp Developer Notes3 4 5 6 7 Network Cable DiagramRack Tray Installation Specifications Specifications Page This product uses UL or CE listed power supplies