Gefen ext-dvikvm-lan user manual Supplementary Connections, RS-232

Page 20

Getting Started

Installation

Supplementary Connections

►► USB (see USB Control for more information on using USB devices)

1.Connect a USB cable from the computer to the USB port on the Sender unit.

2.Connect up to two USB devices to the Receiver unit.

►► IR

3.Connect a Gefen IR Emitter (Gefen part no. EXT-2IREMIT) to the Sender unit and attach it to the IR sensor on the device to be controlled.

4.Connect an IR Extender (Gefen part no. EXT-RMT-EXTIRC or EXT-RMT-EXTIRN) to the Receiver unit if the IR sensor will not be within line-of-site for proper IR control.

►► Audio (see Audio Connections for more information on using audio devices)

7.Connect a 3.5mm mini-stereo cable from the Line In jack on the Sender unit to an audio source.

8.Connect a pair of powered speakers (or another audio output device) to the Line Out jack on the Receiver unit.

9.Connect a microphone to the Mic In jack on the Receiver unit.

10.Connect a pair of powered speakers (or another audio output device) to the Line Out jack on the Sender unit.

►► RS-232

11.Connect the included RS-232 cable from the PC or automation system to the

RS-232port on the Sender unit.

12.Connect an RS-232 cable from the Receiver unit to the RS-232 device to be controlled.

page 10

Image 20
Contents 3GSDIDVI KVM Important Safety Instructions General Safety InformationWarranty Information Product RegistrationContacting Gefen Technical Support Important NoticeOperating Notes Operating Notes Packing List Features and Packing ListFeatures Table of Contents Appendix Page DVI Sender Unit Layout FrontBack Sender Unit LayoutReceiver Unit Layout Receiver Unit Layout Installation Using a Direct ConnectionInstallation Local Area Network LAN Connection Getting Started Supplementary Connections RS-232Sample Wiring Diagram IR EmitterPage Operating DVI KVM over IP Basic Operation Displaying the IP AddressBasic Operation Remote IP = Sender unitOperating the DVI KVM over IP Setting the IP Mode Setting the Video Channel Enabling or Disabling Video over IP Configuring Unicast Mode Unicast and Multicast ModesUnicast and Multicast Modes Switching between Sender units in Unicast mode Unicast mode Receiver unit R1 is connected to Sender unit S2Operating the DVI KVM over IP Operating the DVI KVM over IP Configuring Multicast Mode Operating the DVI KVM over IP Using RS-232 Basic RS-232 connectionUsing RS-232 RS-232 under Unicast Mode RS-232 under Multicast ModeUSB under Unicast Mode USB ControlUSB Control USB under Multicast Mode Configuring Multicast Mode if necessary10 Receiver unit R2 currently has USB control Assigning USB control under Active per request mode Active on link mode Using the Internal DVI Edid Edid ManagementUsing the Downstream Edid Edid ManagementAudio Connections Connect to microphoneAudio Connections Connect to computer speakersUsing Hdmi Sources Setting the Video Mode Video ModeReceiver Unit Performing a Factory ResetSender Unit Page Appendix Upgrading the Firmware Upgrading thePageFirmwarTitle Channels or Less XX denotes the number of maximum channelsAppendix Developer Notes InpNetwork Cable Diagram 3 4 5 6 7Rack Tray Installation Specifications Specifications Page This product uses UL or CE listed power supplies