Gefen ext-dvikvm-lan user manual Network Cable Diagram, 3 4 5 6 7

Page 60

Appendix

Network Cable Diagram

Front of RJ-45 Connector

1 2 3 4 5 6 7 8

Gefen recommends the TIA/EIA-568-B wiring option. Use the table below when field-terminating cable for use with Gefen products.

Pin

1

2

3

4

5

6

7

8

Color	Description
Orange / White	TD+ (Transmit Data, positive differential signal)
Orange	TD- (Transmit Data, negative differential signal)
Green / White	RD+ (Receive Data, positive differential signal)
Blue	Unused
Blue / White	Unused
Green	RD- (Receive Data, negative differential signal)
Brown / White	Unused
Brown / White	Unused

Shielded (STP) CAT-5 or CAT-6 is recommended. However, unshielded (UTP) CAT-5 or CAT-6 is acceptable. CAT-5, CAT-5e, and CAT-6 cabling comes in stranded and solid core types. Gefen recommends using solid core cabling. CAT-6 cable is also recommended.

It is recommended to use one continuous run from one end to the other. Patch cable is not recommended.

page 50

Image 60

Contents 3GSDIDVI KVM Important Safety Instructions General Safety InformationWarranty Information Product RegistrationContacting Gefen Technical Support Important NoticeOperating Notes Operating Notes Features and Packing List FeaturesPacking List Table of Contents Appendix Page DVI Sender Unit Layout FrontBack Sender Unit LayoutReceiver Unit Layout Receiver Unit Layout Installation Using a Direct ConnectionInstallation Local Area Network LAN Connection Getting Started Supplementary Connections RS-232Sample Wiring Diagram IR EmitterPage Operating DVI KVM over IP Basic Operation Displaying the IP AddressBasic Operation Remote IP = Sender unitOperating the DVI KVM over IP Setting the IP Mode Setting the Video Channel Enabling or Disabling Video over IP Configuring Unicast Mode Unicast and Multicast ModesUnicast and Multicast Modes Switching between Sender units in Unicast mode Unicast mode Receiver unit R1 is connected to Sender unit S2Operating the DVI KVM over IP Operating the DVI KVM over IP Configuring Multicast Mode Operating the DVI KVM over IP Using RS-232 Basic RS-232 connectionUsing RS-232 RS-232 under Unicast Mode RS-232 under Multicast ModeUSB under Unicast Mode USB ControlUSB Control USB under Multicast Mode Configuring Multicast Mode if necessary10 Receiver unit R2 currently has USB control Assigning USB control under Active per request mode Active on link mode Using the Internal DVI Edid Edid ManagementUsing the Downstream Edid Edid ManagementAudio Connections Connect to microphoneAudio Connections Connect to computer speakersUsing Hdmi Sources Setting the Video Mode Video ModePerforming a Factory Reset Sender UnitReceiver Unit Page Appendix Upgrading the Firmware Upgrading thePageFirmwarTitle Channels or Less XX denotes the number of maximum channelsAppendix Developer Notes InpNetwork Cable Diagram 3 4 5 6 7Rack Tray Installation Specifications Specifications Page This product uses UL or CE listed power supplies