Operating the DVI KVM over IP
USB Control
USB under Unicast Mode
When connecting USB devices to the DVI KVM over IP, the functionality is similar to that of video and
NOTE: By default, the DVI KVM over IP Sender and Receiver units are shipped in unicast mode.
As an example, we will start with our original diagram and connect a computer to Sender unit S2 and a keyboard and mouse device to Receiver unit R2. This will allow us to control the computer from the Receiver unit.
Figure 2.9 - Using USB devices under unicast mode.
|
| DVI Out | Receiver unit |
|
|
| |
|
|
| 2 |
|
|
| R |
DVI Out | Receiver unit |
|
|
|
|
| |
| 1 |
| 07 |
| R |
|
|
Sender unit
LAN
Sender unit
S3
DVI In
| S |
02 | 2 |
| |
Sender unit |
|
1 | 07 USB cable |
S |
05 | DVI In |
|
09
DVI In
Computer
1.Make sure the desired Sender and Receiver units are set to unicast mode. Refer to
Configuring Unicast Mode if necessary.
2.Access the Web interface for the Sender unit.
3.Click the Functions tab.
page 30