Gefen ext-dvikvm-lan user manual Operating the DVI KVM over IP

Page 36

Operating the DVI KVM over IP

Unicast and Multicast Modes

3.Click the Multicast button under the Network Mode group. When selected, the Multicast button will be highlighted in blue.

4.Click the Save button in the lower-right corner of the Network Mode group.

The following message will be displayed, at the top of the page, indicating that the casting mode has been applied to the Sender or Receiver unit.

If a display is connected to the Receiver unit, then the message “Starting USB” will be displayed. For more information on using USB under multicast mode, refer to USB under Multicast Mode.

5.Click the Reboot button near the bottom portion of the page to apply the changes.

6.Repeat the steps above in order to configure the Sender unit to multicast mode.

IMPORTANT: When changing units between unicast and multicast modes, both the Sender and Receiver units need to be configured identically.

page 26

Page 35 Page 37
Image 36
Page 35 Page 37
Contents 3GSDIDVI KVM Important Safety Instructions General Safety InformationWarranty Information Product RegistrationContacting Gefen Technical Support Important NoticeOperating Notes Operating Notes Features and Packing List FeaturesPacking List Table of Contents Appendix Page DVI Sender Unit Layout FrontBack Sender Unit LayoutReceiver Unit Layout Receiver Unit Layout Installation Using a Direct ConnectionInstallation Local Area Network LAN Connection Getting Started Supplementary Connections RS-232Sample Wiring Diagram IR EmitterPage Operating DVI KVM over IP Basic Operation Displaying the IP AddressBasic Operation Remote IP = Sender unitOperating the DVI KVM over IP Setting the IP Mode Setting the Video Channel Enabling or Disabling Video over IP Configuring Unicast Mode Unicast and Multicast ModesUnicast and Multicast Modes Switching between Sender units in Unicast mode Unicast mode Receiver unit R1 is connected to Sender unit S2Operating the DVI KVM over IP Operating the DVI KVM over IP Configuring Multicast Mode Operating the DVI KVM over IP Using RS-232 Basic RS-232 connectionUsing RS-232 RS-232 under Unicast Mode RS-232 under Multicast ModeUSB under Unicast Mode USB ControlUSB Control USB under Multicast Mode Configuring Multicast Mode if necessary10 Receiver unit R2 currently has USB control Assigning USB control under Active per request mode Active on link mode Using the Internal DVI Edid Edid ManagementUsing the Downstream Edid Edid ManagementAudio Connections Connect to microphoneAudio Connections Connect to computer speakersUsing Hdmi Sources Setting the Video Mode Video ModePerforming a Factory Reset Sender UnitReceiver Unit Page Appendix Upgrading the Firmware Upgrading thePageFirmwarTitle Channels or Less XX denotes the number of maximum channelsAppendix Developer Notes InpNetwork Cable Diagram 3 4 5 6 7Rack Tray Installation Specifications Specifications Page This product uses UL or CE listed power supplies
Top Page Image Contents