Gefen ext-dvikvm-lan user manual Features and Packing List

Page 7

DVI KVM over IP

Features and Packing List

Features

•Extends DVI, USB, RS-232, bi-directional stereo analog audio, and IR over IP, using a Gigabit Local Area Network

•Any combination of HDMI, DVI, and VGA Senders and Receivers can be used

•Supports resolutions up to 1080p Full HD and 1920 x 1200 (WUXGA)

•Built-in Web interface for each Sender and Receiver unit provides intuitive control of all features

•Supports 256 Senders and a total of just over 65,000 Receiver units, depending on the network bandwidth and number of ports of your network switch

•USB 2.0 data rates up to 480 Mbps and backward-compatibility with USB 1.1

•Three-port Gigabit Ethernet switch built into the Receiver unit

•Switch between all available Sender units using the built-in Web interface

•Mode button on Sender for sharpness or motion optimization of image

•Field-upgradable firmware via web server interface

•Locking power supply connectors

•1U tall, half-rack width enclosures are rack-mountable using EXT-RACK-1U

•Surface mounting brackets included

1080P

Packing List

The DVI KVM over IP ships with the items listed below. If any of these items are not present in the box when you first open it, immediately contact your dealer or Gefen.

•1 x DVI KVM over IP (Sender unit)

•1 x DVI KVM over IP (Receiver unit)

•1 x 6 ft. DVI cable (M-M)

•1 x 6 ft. USB cable (A-B)

•1 x 6 ft. DB-9 cable (M-F)

•2 x Mounting rack with screws

•2 x 5V DC power supplies

•1 x Quick-Start Guide

vii

Image 7

Contents 3GSDIDVI KVM General Safety Information Important Safety InstructionsProduct Registration Warranty Information Important Notice Contacting Gefen Technical SupportOperating Notes Operating Notes Features Features and Packing ListPacking List Table of Contents Appendix Page DVI Front Sender Unit LayoutSender Unit Layout BackReceiver Unit Layout Receiver Unit Layout Using a Direct Connection InstallationInstallation Local Area Network LAN Connection Getting Started RS-232 Supplementary ConnectionsIR Emitter Sample Wiring DiagramPage Operating DVI KVM over IP Displaying the IP Address Basic OperationRemote IP = Sender unit Basic OperationOperating the DVI KVM over IP Setting the IP Mode Setting the Video Channel Enabling or Disabling Video over IP Unicast and Multicast Modes Configuring Unicast ModeUnicast and Multicast Modes Unicast mode Receiver unit R1 is connected to Sender unit S2 Switching between Sender units in Unicast modeOperating the DVI KVM over IP Operating the DVI KVM over IP Configuring Multicast Mode Operating the DVI KVM over IP Basic RS-232 connection Using RS-232Using RS-232 RS-232 under Multicast Mode RS-232 under Unicast ModeUSB Control USB under Unicast ModeUSB Control Configuring Multicast Mode if necessary USB under Multicast Mode10 Receiver unit R2 currently has USB control Assigning USB control under Active per request mode Active on link mode Edid Management Using the Internal DVI EdidEdid Management Using the Downstream EdidConnect to microphone Audio ConnectionsConnect to computer speakers Audio ConnectionsUsing Hdmi Sources Video Mode Setting the Video ModeSender Unit Performing a Factory ResetReceiver Unit Page Appendix Upgrading the Firmware Upgrading thePageFirmwarTitle XX denotes the number of maximum channels Channels or LessAppendix Inp Developer Notes3 4 5 6 7 Network Cable DiagramRack Tray Installation Specifications Specifications Page This product uses UL or CE listed power supplies