Operating the DVI KVM over IP
Unicast and Multicast Modes
In order to solve the problem, in Figure 2.4, we would need to make sure that each of the Sender units is set to a unique channel number.
When using unicast mode, each of the Sender units must be assigned a unique channel and should never be changed. Use the Receiver unit to switch (channels) between Sender units.
The DVI KVM over IP can be used with up to 256 Sender units to provide switching capability between each Receiver unit. Up to 256 Receiver units are supported.
Each Receiver unit can be set to receive video data from any one of 256 Sender units.
NOTE: In unicast mode, if an additional Sender unit is introduced into a system with the same channel as another Sender unit, then the Receiver unit will continue to receive A/V data from the Sender unit which was connected first.
page 24