Gefen ext-dvikvm-lan user manual Unicast and Multicast Modes

Page 31

Operating the DVI KVM over IP

Unicast and Multicast Modes

3.Click the Unicast button under the Network Mode group. When selected, the Unicast button will be highlighted in blue.

4.Click the Save button in the lower-right corner of the Network Mode group.

5.The following message will be displayed, at the top of the page, indicating that the casting mode has been applied to the Sender or Receiver unit.

6.Click the Reboot button near the bottom portion of the page to apply the changes.

7.Repeat steps 1 - 6 in order to configure the Sender unit to unicast mode.

IMPORTANT: When switching between unicast and multicast modes, both Sender and Receiver units need to be configured identically.

page 21

Image 31

Contents 3GSDIDVI KVM General Safety Information Important Safety InstructionsProduct Registration Warranty InformationImportant Notice Contacting Gefen Technical SupportOperating Notes Operating Notes Features Features and Packing ListPacking List Table of Contents Appendix Page DVI Front Sender Unit LayoutSender Unit Layout BackReceiver Unit Layout Receiver Unit Layout Using a Direct Connection InstallationInstallation Local Area Network LAN Connection Getting Started RS-232 Supplementary ConnectionsIR Emitter Sample Wiring DiagramPage Operating DVI KVM over IP Displaying the IP Address Basic OperationRemote IP = Sender unit Basic OperationOperating the DVI KVM over IP Setting the IP Mode Setting the Video Channel Enabling or Disabling Video over IP Unicast and Multicast Modes Configuring Unicast ModeUnicast and Multicast Modes Unicast mode Receiver unit R1 is connected to Sender unit S2 Switching between Sender units in Unicast modeOperating the DVI KVM over IP Operating the DVI KVM over IP Configuring Multicast Mode Operating the DVI KVM over IP Basic RS-232 connection Using RS-232Using RS-232 RS-232 under Multicast Mode RS-232 under Unicast ModeUSB Control USB under Unicast ModeUSB Control Configuring Multicast Mode if necessary USB under Multicast Mode10 Receiver unit R2 currently has USB control Assigning USB control under Active per request mode Active on link mode Edid Management Using the Internal DVI EdidEdid Management Using the Downstream EdidConnect to microphone Audio ConnectionsConnect to computer speakers Audio ConnectionsUsing Hdmi Sources Video Mode Setting the Video ModeSender Unit Performing a Factory ResetReceiver Unit Page Appendix Upgrading the Firmware Upgrading thePageFirmwarTitle XX denotes the number of maximum channels Channels or LessAppendix Inp Developer Notes3 4 5 6 7 Network Cable DiagramRack Tray Installation Specifications Specifications Page This product uses UL or CE listed power supplies