Operating the DVI KVM over IP
Unicast and Multicast Modes
Switching between Sender units in Unicast mode
When multiple Sender and Receiver unit are used in unicast mode, the DVI KVM over IP behaves as a switcher. In unicast mode, a Sender unit can communicate with only one Receiver unit at a time.
In the example below, we will switch Receiver unit R1 to receive the DVI source on Sender unit S1.
Figure 2.2 - Unicast mode: Receiver unit R1 is connected to Sender unit S2.
DVI Out | Receiver unit |
LAN
2
DVI Out | Receiver unit |
|
1 
R1
R2
2
Sender unit
Sender unit
S3
DVI In
| 1 | S2 |
| Sender unit |
|
5 |
| DVI In |
S |
| |
| 1 |
|
DVI In
1.Access the Web interface for Receiver unit R1.
2.Click the Network tab and change the video channel. Refer to Setting the Video
Channel if necessary.
3.Click the Save button.
4.The following message will be displayed, at the top of the page, indicating that the casting mode has been applied to the Sender or Receiver unit.
5.Receiver unit R1 is now receiving the DVI source on Sender unit S1, as shown on the next page.
page 22