Freescale Semiconductor M9328MX21ADSE 12 SD/MMC Connector, Extension and Image Sensor Connectors

Support Information

3.12SD/MMC Connector

Connector P6 is the ADS SD/MMC connector. Figure 3-16gives the pin assignments and Table 3-16gives the signal descriptions for this connector.

11108 7	6	5	4	3	2	1	9	13
12								14

Figure 3-16. SD/MMC Connector P6 Pin Assignments

Table 3-16. SD/MMC Connector P6 Signal Descriptions

			Description
Pin(s)	Signal	MMC Card	SD Card
			1-Bit Mode		4-Bit Mode
1	SD1_DAT3	Reserved	Not Used		Data Line DAT3
2	SD1_CMD		Command / Response
3, 6, 11	GND		GROUND
4	VCC		+3 VDC power
5	SD1_CLK		Clock
7	SD1_DAT0		Data Line DAT0
8	SD1_DAT1	Not Used	Interrupt (IRQ)		Data Line DAT1 or
					Interrupt (IRQ)
9	SD1_DAT2	Not Used	ReadWait (RW)		Data Line DAT2 or
					Read Wait (RW)
10	CSPI1_RDY	Card	Detect, configured as	GPIO, PB20
12	SD_WP	Write Protect Detect, connects to I/O input bit 0
13, 14	NC		No Connection

3.13Extension and Image Sensor Connectors

Connectors PE1, PE2 and PE3 are 16 x 3-pin DIN type connectors. PE1 is a connector for the Image Sensor module included with the ADS. PE2 and PE3 are Extension connectors that provide most of the MC9328MX21 signals other than data bus, address bus, EIM control signals, and SDRAM control signals.

Figure 3-17shows the pin numbering for the PE1, PE2, and PE3 connectors. Table 3-17through Table 3-19provide signal descriptions. Table 3-17covers PE1, Table 3-18covers PE2 and Table 3-19covers PE3.

M9328MX21ADSE User’s Manual, Rev. A

3-28 Freescale Semiconductor