Support Information
Table 3-19. Extension Connector PE3 Signal Description (continued)
Pin(s) | Signal | Description |
|
|
|
B14 | USBH1_FS | USB FULL SPEED |
|
|
|
B15 | USBH1_OE_B | USB OUTPUT ENABLE |
|
|
|
B16 | USBH_ON_B | USB transceiver ON |
|
|
|
C1 | GND | GROUND |
|
|
|
C2 | TIN | TIMER INPUT CAPTURE — Timer input |
|
|
|
C3 | TOUT | TIMER OUTPUT COMPARE — Timer output |
|
|
|
C4 | SD2_CLK | SD/MMC CLOCK — Clock output to SD/MMC card |
|
|
|
C5 | SD2_CMD | SD/MMC COMMAND — Serial command bit to SD/MMC card, bidirectional |
|
|
|
C6 | SD2_D3 | SD/MMC DATA BIT 3 — Serial data bit to SD/MMC card, bidirectional |
|
|
|
C7 | SD2_D2 | SD/MMC DATA BIT 2 — Serial data bit to SD/MMC card, bidirectional |
|
|
|
C8 | SD2_D1 | SD/MMC DATA BIT 1 — Serial data bit to SD/MMC card, bidirectional |
|
|
|
C9 | SD2_D0 | SD/MMC DATA BIT 0 — Serial data bit to SD/MMC card, bidirectional |
|
|
|
C10 | PWMO | PULSE WIDTH MODULATOR OUTPUT |
|
|
|
C11 | RESET_OUT_B | RESET OUT — Active low reset signal from the processor |
|
|
|
C12 | RTCK_GPIO | RETURN CLOCK — JTAG signal, can be general purpose I/O |
|
|
|
C13 | USB_OC_B | USB OVER CURRENT input active low |
|
|
|
C14 | USB_PWR | USB POWER |
|
|
|
C15 | USB_BYP_B | USB BY PASS input active low |
|
|
|
C16 | VCC | +3 VDC power |
|
|
|
3.14Disposal Information
This symbol means this product may be subject to special disposal requirment.
For product disposal information, please refer to http://www.freescale.com/productdisposal.
| M9328MX21ADSE User’s Manual, Rev. A |
Freescale Semiconductor |