Freescale Semiconductor user manual System and User Requirements, M9328MX21ADSE Diagram

General Information

•Separate CMOS Image Sensor Card

•Audio CODEC includes an 11.28 MHz crystal oscillator, a 3.5 mm audio input jack, a 3.5 mm microphone jack, and a 3.5 mm headphone jack

•Cirrus Logic CS8900A-CQ3Z Ethernet controller, with RJ-45 connector for connecting to a system hub

•Two 32 ⋅ 3-pin DIN expansion connectors with most i.MX21 I/O signals

•Variable resistor for emulation of a battery voltage level

•NAND Flash card (Plugs into CPU Board)

•LED indicators for power, external bus activity, Ethernet activity, and two LEDs for user defined status indiction

•Universal power supply with 5.0-volt output @ 2.4 Amperes

•USB cable

•RS-232 serial cable

•Two RJ-45 Ethernet cables, network, and crossover

1.3System and User Requirements

To use the ADS, you need:

•An IBM PC or compatible computer that has:

—A Windows→ 98, Windows ME™, Windows XP™, Windows 2000, or Windows NT→ (version 4.0) operating system

—A parallel port and a Multi-ICE device (not included)

•A + 5 VDC power supply @ 2.4 A, with a 2 mm female (inside positive) power connector (included)

CAUTION

Never supply more than +5.5-volts power to your M9328MX21ADSE.

Doing so can damage board components.

1.4M9328MX21ADSE Diagram

Figure 1-1shows the connectors and other major parts of the ADS Base board and CPU board.

	M9328MX21ADSE User’s Manual, Rev. A
1-2	Freescale Semiconductor