Eizo CG245W user manual Setting Calibration Details Setting, Setting the calibration targets

4-3. Setting Calibration Details [Setting]

●Setting the mode to execute SelfCalibration [Mode Selection]

Set the mode to execute SelfCalibration.

Procedure

1.Choose <Setting> from the SelfCalibration menu, and press .

2.Choose <Mode Selection> from the Setting menu, and press .

3.Select the mode to change with or , and press .

4.Select “On” or “Off” with or.

5.Press to exit the adjustment.

NOTE

•When “CAL1/CAL2/CAL3” is set to “On”, SelfCalibration can be executed.

•When “Other Modes” is set to “On”, the monitor color reproduction area is updated and the display in each color mode will be adjusted as follows:

-In any mode other than CAL mode, the temperature is adjusted so that it is as close as possible to the specified value.

-In Adobe RGB/sRGB/EBU/REC709/SMPTE-C/DCI modes, the gamut values are adjusted so that they are close to each specified value.

●Setting the calibration targets

Set the calibration targets for SelfCalibration.

Procedure

1.Choose <Setting> from the SelfCalibration menu, and press .

2.Choose <Target> from the Setting menu, and press .

3.Select the items to change with or , and press . The target setting menu is displayed.

4.Select the items to change with or , and press .

Setting Item		Setting Range		Setting
Brightness	30 - 250 cd/m2		Set the brightness of the monitor using
			the brightness value (cd/m2).
White Point	Color	: 0.2400 - 0.4500 *1	Set the monitor White Point using the
	coordinates		color coordinate or Temperature.
	Temperature	: 4000 - 10000K (100K Unit)*2
Color Gamut	Native/User		Set whether to calibrate color gamut.
			Native	: Color gamut calibration is
				not performed.
			User	: Color gamut calibration is
				performed.
	0.0000 - 1.0000		To calibrate the monitor color
	(For each of Red/Green/Blue)		reproduction gamut, set the color
			coordinates for red, green, and blue.
Gamma	1.6 - 2.7 (0.1 Unit)*3		Set the monitor gamma values.

*1 When the color coordinates are set, the temperature changes to [User].

*2 When the temperature is set, the x and y coordinates of the white point are set automatically. *3 These become [Fixed] when calibrating with ColorNavigator.

5.Adjust using or .

6.Press to exit the adjustment. The calibration targets are set.

Attention

•Only set the color gamut calibration when the target color range is precisely known.

•If ColorNavigator was used to calibrate the grey balance, do not change the gamma setting values.

NOTE

• The calibration targets set using ColorNavigator are set as the calibration targets for the monitor.

Chapter 4 SelfCalibration 33