EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge „ Uploading Configuration Files

Page 12

2.4.8Back-up the Wireless client bridge’s Configuration

Files

After configuring Wireless client bridge, user can back-up the configuration files. User can upload the latest back-up files and recover the Wireless client bridge configuration to the settings specified in the back-up files.

„Downloading Configuration Files

Just being the same with firmware upgrade procedures. After the prompt character NetARM> is displayed, select “S – Save image to file”, and then select “6: CONFIG” to back-up the Wireless client bridge configuration as the figure shown below. The back-up file will be saved as <CONFIG.IMG> file.

Note: Remember to press “R” to reboot the system after you upload the configuration file to the Wireless client bridge

„Uploading Configuration Files

To upload an configuration file to Wireless client bridge, user should select “F -- upgrade Flash memory” and then select “6: CONFIG”. While the window starts to display “C” character continuously, click Transfer and select the preferred <CONFIG.IMG>, then press OK to start transferring file to Wireless client bridge.

Version 1.02

20

Version 1.02

21

Image 12
Contents Ieee 802.11b Outdoor Wireless Client Bridge Introduction Introducing the Wireless client bridge Product FeaturesPackage Contents Inline Power Injector PoE Installation and Basic ConfigurationSystem Requirements Before You Start„ Interface on the Wireless client bridge Unit Before After „ Interface on the Inline Power InjectorPreparing Installation Basic Configuration Basic Configuration StepsMove to page /Utility/Administration/, select What you need to knowLogin into the Web Interface „ Web Configuration„ Web Access Procedures „ Identify the IP Address assigned to the unitSet IP Address, Subnet Mask, Default Route IP „ Web Configuration Structure„ Host Information Set Wireless Encryption for Wireless Interface Change Supervisor Account & PasswordUpgrade the Firmware „ Setup your Tftp Server„ Update the Firmware using the Tftp method „ Upgrade the Firmware using RS-232 consoleVersion Back-up the Wireless client bridge’s Configuration Files „ Downloading Configuration Files„ Uploading Configuration Files Wireless Client Bridge-to-Central Wireless Bridge Network TopologiesRemarks Version Wireless Client Router-to-Central Wireless Router Network Parameters IP Configuration Configure SnmpConfigure Community Pool „ Wireless Client BridgeConfigure Trap Host Pool Configure Wireless related parameters Software Upgrade UtilityAdministration „ Services InformationMonitor Information „ General System InformationSystem Information Statistic InformationStatistic of Interface Site Survey Wireless Link Information Specifications Hardware Specifications Software Specifications Default Settings General ConfigurationSystem Snmp Table of Snmp Community PoolWireless LAN Table of Snmp Trap Community Host PoolRegulatory Compliance Information „ Radio Frequency Interference Requirements„ Radiation Exposure Statement „ Interference Statement„ Professional Installation „ European Community CE Notice Marking by the symbol: