EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge user manual Basic Configuration

Page 6

NOTE: This connection is required for setting up initial configuration information. After configuration is completed, the RS-232 null modem console cable shall be removed, and run a cross-over Ethernet cable from Data Input Port to PC, or a straight Ethernet cable to LAN connection, e.g. Hub.

Step 5 Attach one straight Ethernet cable to the Power & Data Output Port on the Inline Power Injector(refer to page 5).

Step 6 Plug the other end of the straight Ethernet cable to the Ethernet Port (refer to page 5) on the Wireless client bridge.

When the Wireless client bridge receives power over the Ethernet cable, the Wireless client bridge will start its boot sequence and the Active LED on the Inline Power Injector will light up.

You can configure the Wireless client bridge via HTML browser, such as Microsoft Internet Explorer or Netscape Navigator from a remote host or PC.

2.4Basic Configuration

2.4.1 What you need to know

The Wireless client bridge can be configured into two operation roles, including Wireless Client Bridge and Wireless Client Router.

The Wireless client bridge is shipped with default configuration to function as a client bridge between an Ethernet and Wireless network by attaching Wireless client bridge to the wired LAN simply. If user would configure Wireless client bridge, please refer to the following procedures.

2.4.2 Basic Configuration Steps

This section describes a five-step configuration procedure to setup Wireless client bridge workable upon your topology requirement.

Step 1 Select an operation mode for Wireless client bridge on the web page “/General Config/System/”, and click FINISH to refresh this page.

Step 2 Modify the factory-default parameters on the web page “/General

Config/System/”, and click FINISH to save the changes.

Step 3 Modify the factory-default parameters on the web page “/General Config/Wireless/”, and click FINISH to save the changes.

Step 4 (Optional) Modify other parameters on the web page “/General Config/”, and click FINISH to save the changes.

Step 5 Move to page “/Utility/Administration/”, select the

Save

then Restart and then click FINISH to take effect on the previous configuration changes.

Version 1.02

8

Version 1.02

9

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Ieee 802.11b Outdoor Wireless Client Bridge Introduction Introducing the Wireless client bridge Product FeaturesPackage Contents System Requirements Inline Power Injector PoEInstallation and Basic Configuration Before You Start„ Interface on the Wireless client bridge Unit Before After „ Interface on the Inline Power InjectorPreparing Installation Move to page /Utility/Administration/, select Basic ConfigurationBasic Configuration Steps What you need to know„ Web Access Procedures Login into the Web Interface„ Web Configuration „ Identify the IP Address assigned to the unitSet IP Address, Subnet Mask, Default Route IP „ Web Configuration Structure„ Host Information Set Wireless Encryption for Wireless Interface Change Supervisor Account & Password„ Update the Firmware using the Tftp method Upgrade the Firmware„ Setup your Tftp Server „ Upgrade the Firmware using RS-232 consoleVersion Back-up the Wireless client bridge’s Configuration Files „ Downloading Configuration Files„ Uploading Configuration Files Wireless Client Bridge-to-Central Wireless Bridge Network TopologiesRemarks Version Wireless Client Router-to-Central Wireless Router Configure Community Pool Network Parameters IP ConfigurationConfigure Snmp „ Wireless Client BridgeConfigure Trap Host Pool Configure Wireless related parameters Software Upgrade UtilityMonitor Information Administration„ Services Information „ General System InformationSystem Information Statistic InformationStatistic of Interface Site Survey Wireless Link Information Specifications Hardware Specifications System Software SpecificationsDefault Settings General Configuration Snmp Table of Snmp Community PoolWireless LAN Table of Snmp Trap Community Host Pool„ Radiation Exposure Statement Regulatory Compliance Information„ Radio Frequency Interference Requirements „ Interference Statement„ Professional Installation „ European Community CE Notice Marking by the symbol：
Top Page Image Contents