EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge user manual

Page 9

„IP Use MAC Addr.

You can choice Enable or Disable. If you choice Enable , it will set IP = 10.X.X.X that used to last 3 MAC Address ID.

For example :

MAC Addr = 00:47:55:43:43:49 => IP = 10.67.67.73(43hex=67decimal) If you choice Disable you need setting Bridge IP Address Information.

„Bridge IP Address

Use this setting to assign or change the Wireless client bridge IP address.

„Bridge Subnet Mask

Enter an IP subnet mask to identify the sub network so the IP address can be recognized on the LAN.

„Default Gateway IP Address

Enter the default Gateway IP Address, and click FINISH at the bottom of this page to complete the modification of this page.

2.4.5 Set Wireless Encryption for Wireless Interface

The Wireless client bridge supports 64-bit and 128-bit WEP encryption.

For 64-bitWEP encryption, an encryption key is 10 hexadecimal characters (0-9 and A-F) or 5 ASCII characters.

For 128-bitWEP encryption, an encryption key is 26 hexadecimal characters or 13 ASCII characters.

Modify the WEP encryption parameters on the web page “/General Config/Woreless/”. Enter 1~15 characters into the WEP Key field, and click KeyGen to generate the WEP64 or WEP128 key patterns.

2.4.6 Change Supervisor Account & Password

Enter the Utility > Administration page. The figure below shows the Utility/ Administration page.

„Supervisor Account

Change the supervisor’s user name and password in the Supervisor Account field, and click FINISH to take effect on the previous configuration changes.

„Apply the New Settings

Step 1 Enter the Utility > Administration page, select the Save then Restart to apply the new configuration settings.

Step 2 Click FINISH to take effect on the previous configuration changes.

Hint: It takes about 10 seconds, to complete the restart process.

Version 1.02

14

Version 1.02

15

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Ieee 802.11b Outdoor Wireless Client Bridge Introduction Introducing the Wireless client bridge Product FeaturesPackage Contents Installation and Basic Configuration Inline Power Injector PoESystem Requirements Before You StartBefore After „ Interface on the Inline Power Injector „ Interface on the Wireless client bridge UnitPreparing Installation Basic Configuration Steps Basic ConfigurationMove to page /Utility/Administration/, select What you need to know„ Web Configuration Login into the Web Interface„ Web Access Procedures „ Identify the IP Address assigned to the unitSet IP Address, Subnet Mask, Default Route IP „ Web Configuration Structure„ Host Information Change Supervisor Account & Password Set Wireless Encryption for Wireless Interface„ Setup your Tftp Server Upgrade the Firmware„ Update the Firmware using the Tftp method „ Upgrade the Firmware using RS-232 consoleVersion Back-up the Wireless client bridge’s Configuration Files „ Downloading Configuration Files„ Uploading Configuration Files Wireless Client Bridge-to-Central Wireless Bridge Network TopologiesRemarks Version Wireless Client Router-to-Central Wireless Router Configure Snmp Network Parameters IP ConfigurationConfigure Community Pool „ Wireless Client BridgeConfigure Trap Host Pool Configure Wireless related parameters Utility Software Upgrade„ Services Information AdministrationMonitor Information „ General System InformationSystem Information Statistic InformationStatistic of Interface Site Survey Wireless Link Information Specifications Hardware Specifications Default Settings General Configuration Software SpecificationsSystem Snmp Table of Snmp Community PoolTable of Snmp Trap Community Host Pool Wireless LAN„ Radio Frequency Interference Requirements Regulatory Compliance Information„ Radiation Exposure Statement „ Interference Statement„ European Community CE Notice Marking by the symbol： „ Professional Installation
Top Page Image Contents