EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge user manual Version

Page 11

shown below.

Step 2 Press <Esc> keystroke to reboot the Wireless client bridge. Press <x> key during the boot process, and it will display prompt character NetARM> as the figure shown in the next page.

Step 3 Press “h” keystroke, it will display related commands as the figure shown below.

Step 4 Select “F -- upgrade Flash memory” and it will display upgrade items for selection as the figure shown below.

Step 5 Select “3: SOHO” and select “4: WEBIMG” to update the firmware files one by one.

Step 6 While the window starts to display “C” character continuously, click Transfer and select the new firmware files <soho.bin> file, press “OK” to start to transfer file to Wireless client bridge.

Step 7 Select “4” to upgrade WEBIMG file. The procedures are the same with upgrading SOHO file (go back to step 5), but should select <pfs.img> file correctly for WEBIMG file upgrade.

Step 8 After the upgrade completes, remember to press “R” keystroke to reboot the system.

Note: The default transfer protocol is using “Xmodem”, so please make sure you select correct protocol to download/upload files when you try to upgrade the Wireless client bridge’s firmware files.

Version 1.02

18

Version 1.02

19

Image 11
Contents Ieee 802.11b Outdoor Wireless Client Bridge Package Contents Introduction Introducing the Wireless client bridgeProduct Features Before You Start Inline Power Injector PoEInstallation and Basic Configuration System RequirementsBefore After „ Interface on the Inline Power Injector „ Interface on the Wireless client bridge UnitPreparing Installation What you need to know Basic ConfigurationBasic Configuration Steps Move to page /Utility/Administration/, select„ Identify the IP Address assigned to the unit Login into the Web Interface„ Web Configuration „ Web Access Procedures„ Host Information Set IP Address, Subnet Mask, Default Route IP„ Web Configuration Structure Change Supervisor Account & Password Set Wireless Encryption for Wireless Interface„ Upgrade the Firmware using RS-232 console Upgrade the Firmware„ Setup your Tftp Server „ Update the Firmware using the Tftp methodVersion „ Uploading Configuration Files Back-up the Wireless client bridge’s Configuration Files„ Downloading Configuration Files Remarks Wireless Client Bridge-to-Central Wireless BridgeNetwork Topologies Version Wireless Client Router-to-Central Wireless Router „ Wireless Client Bridge Network Parameters IP ConfigurationConfigure Snmp Configure Community PoolConfigure Trap Host Pool Configure Wireless related parameters Utility Software Upgrade„ General System Information Administration„ Services Information Monitor InformationStatistic of Interface System InformationStatistic Information Site Survey Wireless Link Information Specifications Hardware Specifications Snmp Table of Snmp Community Pool Software SpecificationsDefault Settings General Configuration SystemTable of Snmp Trap Community Host Pool Wireless LAN„ Interference Statement Regulatory Compliance Information„ Radio Frequency Interference Requirements „ Radiation Exposure Statement„ European Community CE Notice Marking by the symbol: „ Professional Installation