EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge user manual

Page 15

3.4Wireless Client Router-to-Central Wireless Router

Step 1 Set the COU to perform a Wireless Router (Wireless Interface IP: 192.168.1.1, Ethernet Interface IP: 192.168.2.1, default route: 192.168.2.254).

Step 2 Set Wireless parameters on COU: Channel (1) and SSID (wireless).

Step 3 Set the ROU to perform a Wireless Router (Wireless Interface IP: 192.168.1.2, Ethernet Interface IP: 192.168.10.1, default route: 192.168.1.1).

Step 4 Set Wireless parameters on ROU: Channel (1) and SSID (wireless), and these parameters must be the same with COU.

Step 5 Set the DHCP server service on the ROU and apply it on Ethernet Interface.

Step 6 The ROU assigns IP addresses to PC1 and PC2.

The operator can also disable NAT behavior on COU and enable NAT behavior on ROU (enable NAT on Wireless Interface). In this case, any outgoing packets will transfer to 192.168.1.2.

The operator can also enable NAT behavior on COU (enable NAT on Ethernet interface) and enable NAT behavior on ROU (enable NAT on Wireless Interface).

Version 1.02

26

Version 1.02

27

Image 15

Contents Ieee 802.11b Outdoor Wireless Client Bridge Introduction Introducing the Wireless client bridge Product FeaturesPackage Contents Before You Start Inline Power Injector PoEInstallation and Basic Configuration System RequirementsBefore After „ Interface on the Inline Power Injector „ Interface on the Wireless client bridge UnitPreparing Installation What you need to know Basic ConfigurationBasic Configuration Steps Move to page /Utility/Administration/, select„ Identify the IP Address assigned to the unit Login into the Web Interface„ Web Configuration „ Web Access ProceduresSet IP Address, Subnet Mask, Default Route IP „ Web Configuration Structure„ Host Information Change Supervisor Account & Password Set Wireless Encryption for Wireless Interface„ Upgrade the Firmware using RS-232 console Upgrade the Firmware„ Setup your Tftp Server „ Update the Firmware using the Tftp methodVersion Back-up the Wireless client bridge’s Configuration Files „ Downloading Configuration Files„ Uploading Configuration Files Wireless Client Bridge-to-Central Wireless Bridge Network TopologiesRemarks Version Wireless Client Router-to-Central Wireless Router „ Wireless Client Bridge Network Parameters IP ConfigurationConfigure Snmp Configure Community PoolConfigure Trap Host Pool Configure Wireless related parameters Utility Software Upgrade„ General System Information Administration„ Services Information Monitor InformationSystem Information Statistic InformationStatistic of Interface Site Survey Wireless Link Information Specifications Hardware Specifications Snmp Table of Snmp Community Pool Software SpecificationsDefault Settings General Configuration SystemTable of Snmp Trap Community Host Pool Wireless LAN„ Interference Statement Regulatory Compliance Information„ Radio Frequency Interference Requirements „ Radiation Exposure Statement„ European Community CE Notice Marking by the symbol： „ Professional Installation