EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge user manual Configure Snmp

Page 16

Chapter 4. Network Parameters

4.1IP Configuration

„Wireless Client Bridge

Step 1 Enter the IP Address manually into the Bridge IP Address field.

Step 2 Use Bridge IP Address setting to assign or change the bridge’s IP address.

Step 3 Click FINISH at the bottom of this page to complete the modification of IP address.

4.2Configure SNMP

Select the “/General Config/ TCP/IP/SNMP”, and the SNMP screen appears. The figure below shows the current SNMP community pool and trap host pool.

4.2.1 Configure Community Pool

The SNMP Community Pool has five entries.

1.To modify the entry, click the select button beside the entry index number and click Modify. The configuration page appears as the figure shown below.

2.Specify the Validity, Access Right and Community field.

9Validity. Select Enable or Disable to control this community.

9Access Right. Select a command from the pull down menu for this field.

9Community. Enter the password related the Access Right in this field.

3.Click OK to refresh the current community pool.

4.To modify another community entry to the current community pool, repeat step 1 through step 3.

5.When you have modified all the entries preferred, click FINISH.

Version 1.02

28

Version 1.02

29

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Ieee 802.11b Outdoor Wireless Client Bridge Product Features Introduction Introducing the Wireless client bridgePackage Contents Inline Power Injector PoE Installation and Basic ConfigurationSystem Requirements Before You Start„ Interface on the Wireless client bridge Unit Before After „ Interface on the Inline Power InjectorPreparing Installation Basic Configuration Basic Configuration StepsMove to page /Utility/Administration/, select What you need to knowLogin into the Web Interface „ Web Configuration„ Web Access Procedures „ Identify the IP Address assigned to the unit„ Web Configuration Structure Set IP Address, Subnet Mask, Default Route IP„ Host Information Set Wireless Encryption for Wireless Interface Change Supervisor Account & PasswordUpgrade the Firmware „ Setup your Tftp Server„ Update the Firmware using the Tftp method „ Upgrade the Firmware using RS-232 consoleVersion „ Downloading Configuration Files Back-up the Wireless client bridge’s Configuration Files„ Uploading Configuration Files Network Topologies Wireless Client Bridge-to-Central Wireless BridgeRemarks Version Wireless Client Router-to-Central Wireless Router Network Parameters IP Configuration Configure SnmpConfigure Community Pool „ Wireless Client BridgeConfigure Trap Host Pool Configure Wireless related parameters Software Upgrade UtilityAdministration „ Services InformationMonitor Information „ General System InformationStatistic Information System InformationStatistic of Interface Site Survey Wireless Link Information Specifications Hardware Specifications Software Specifications Default Settings General ConfigurationSystem Snmp Table of Snmp Community PoolWireless LAN Table of Snmp Trap Community Host PoolRegulatory Compliance Information „ Radio Frequency Interference Requirements„ Radiation Exposure Statement „ Interference Statement„ Professional Installation „ European Community CE Notice Marking by the symbol：
Top Page Image Contents