EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge user manual Version

Page 14

3.2 Wireless Client Router-to-Central Wireless	3.3 Wireless Client Bridge-to-Central Wireless
Bridge	Router

Step 1 Set the COU to perform a bridge (bridge IP address: 192.168.2.1).

Step 2 Set Wireless parameters on COU: Channel (1) and SSID (wireless).

Step 3 Set the ROU to perform a Router (Wireless Interface IP: 192.168.2.2, Ethernet Interface IP: 192.168.10.1). It is a must to enable NAT on Wireless Interface (default route is 192.168.2.254).

Step 4 Set Wireless parameters on ROU: Channel (1) and SSID (wireless), these parameters must same with COU.

Step 5 Set the DHCP server service on the ROU and apply it on Ethernet Interface.

Step 6 The ROU assigns IP addresses to PC1 and PC2

Step 1 Set the COU to perform a Wireless Router (Wireless Interface IP: 192.168.1.1, Ethernet Interface IP: 192.168.2.1). It is a must to enable NAT on Ethernet interface (default route: 192.168.2.254).

Step 2 Set Wireless parameters on COU: Channel (1) and SSID (wireless)

Step 3 Set the DHCP server service on the COU and apply it on Wireless Interface.

Step 4 Set the ROU to perform a Bridge (Bridge Interface IP: 192.168.1.2).

Step 5 Set Wireless parameters on ROU: Channel (1) and SSID (wireless), and these parameters must be the same with the COU.

Step 6 The COU assigns IP addresses to PC1 and PC2.

Step 7 The operator can also disable NAT behavior on COU to make the two subnets transparent.

Version 1.02

24

Version 1.02

25

Image 14

Contents Ieee 802.11b Outdoor Wireless Client Bridge Package Contents Introduction Introducing the Wireless client bridgeProduct Features System Requirements Inline Power Injector PoEInstallation and Basic Configuration Before You Start„ Interface on the Wireless client bridge Unit Before After „ Interface on the Inline Power InjectorPreparing Installation Move to page /Utility/Administration/, select Basic ConfigurationBasic Configuration Steps What you need to know„ Web Access Procedures Login into the Web Interface„ Web Configuration „ Identify the IP Address assigned to the unit„ Host Information Set IP Address, Subnet Mask, Default Route IP„ Web Configuration Structure Set Wireless Encryption for Wireless Interface Change Supervisor Account & Password„ Update the Firmware using the Tftp method Upgrade the Firmware„ Setup your Tftp Server „ Upgrade the Firmware using RS-232 consoleVersion „ Uploading Configuration Files Back-up the Wireless client bridge’s Configuration Files„ Downloading Configuration Files Remarks Wireless Client Bridge-to-Central Wireless BridgeNetwork Topologies Version Wireless Client Router-to-Central Wireless Router Configure Community Pool Network Parameters IP ConfigurationConfigure Snmp „ Wireless Client BridgeConfigure Trap Host Pool Configure Wireless related parameters Software Upgrade UtilityMonitor Information Administration„ Services Information „ General System InformationStatistic of Interface System InformationStatistic Information Site Survey Wireless Link Information Specifications Hardware Specifications System Software SpecificationsDefault Settings General Configuration Snmp Table of Snmp Community PoolWireless LAN Table of Snmp Trap Community Host Pool„ Radiation Exposure Statement Regulatory Compliance Information„ Radio Frequency Interference Requirements „ Interference Statement„ Professional Installation „ European Community CE Notice Marking by the symbol：