EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge user manual

Page 4

2.2Locate the Wireless client bridge and Inline Power Injector Ports

„Interface on the Wireless client bridge Unit

9Ethernet Port 1 for connecting the RJ-45 CAT-5 Ethernet cable.

9RS-232 Console Port 2 for connecting the 1.8m RS-232 null modem console cable.

NOTE: The RJ-45 Ethernet cable is not provided in Wireless client bridge shipping package as an accessory. User can find one from computer store in accordance with the length required for outdoor deployment.

NOTE: How to make up Water protect kit

PS：1.Red line is RJ-45 cable

2.Use dryer blew Ardent shrink casing pipe

Before

After

„Interface on the Inline Power Injector

9Data Input Port 3 for connecting cross-over Ethernet Cable to PC or straight Ethernet cable to Hub Switch Router.

9110~240VAC, 50~60Hz AC/DC power adapter DC Input Port 4

9Power & Data Output Port 5 for connecting the 30m RJ-45 CAT-5 Ethernet Cable.

9Grounding Port 6.

NOTE: The cross-over or straight type Ethernet cable is not provided in Wireless client bridge shipping package as an accessory. User can find one from computer store in accordance with the length required for indoor deployment.

21

3

4

5

6

 

 

 

 

„Mount Wireless client bridge on A Wall/Pole

The Wireless client bridge can be mounted on the wall, you can use the Wall Mount kit to mount the Wireless client bridge as shown in Figure 2.2.1.

Version 1.02

4

Version 1.02

5

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Ieee 802.11b Outdoor Wireless Client Bridge Product Features Introduction Introducing the Wireless client bridgePackage Contents Inline Power Injector PoE Installation and Basic ConfigurationSystem Requirements Before You Start„ Interface on the Wireless client bridge Unit Before After „ Interface on the Inline Power InjectorPreparing Installation Basic Configuration Basic Configuration StepsMove to page /Utility/Administration/, select What you need to knowLogin into the Web Interface „ Web Configuration„ Web Access Procedures „ Identify the IP Address assigned to the unit„ Web Configuration Structure Set IP Address, Subnet Mask, Default Route IP„ Host Information Set Wireless Encryption for Wireless Interface Change Supervisor Account & PasswordUpgrade the Firmware „ Setup your Tftp Server„ Update the Firmware using the Tftp method „ Upgrade the Firmware using RS-232 consoleVersion „ Downloading Configuration Files Back-up the Wireless client bridge’s Configuration Files„ Uploading Configuration Files Network Topologies Wireless Client Bridge-to-Central Wireless BridgeRemarks Version Wireless Client Router-to-Central Wireless Router Network Parameters IP Configuration Configure SnmpConfigure Community Pool „ Wireless Client BridgeConfigure Trap Host Pool Configure Wireless related parameters Software Upgrade UtilityAdministration „ Services InformationMonitor Information „ General System InformationStatistic Information System InformationStatistic of Interface Site Survey Wireless Link Information Specifications Hardware Specifications Software Specifications Default Settings General ConfigurationSystem Snmp Table of Snmp Community PoolWireless LAN Table of Snmp Trap Community Host PoolRegulatory Compliance Information „ Radio Frequency Interference Requirements„ Radiation Exposure Statement „ Interference Statement„ Professional Installation „ European Community CE Notice Marking by the symbol：
Top Page Image Contents