Enterasys Networks ANG-1100 manual Iii

Page 3

Federal Communications Commission (FCC) Notices

The Aurorean Network Gateway-1102/1105 complies with Title 47 Part 15, Class B of FCC rules. Operation is subject to the following two conditions:

This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause undesired operation.

Modifications or changes made to this device, and not approved by Enterasys Networks may void the authority granted by the FCC or other such agency to operate this equipment.

There are no user-repairable components in the Aurorean Network Gateway-1102/1105.

Canadian Notices

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the interference-causing equipment standard entitled “Digital Apparatus”, ICES-003 of the Department of Communications (Cet appareil numérique respecte les limites bruits radioélectriques applicables aux appareils numériques de Classe A prescrites dans la norme sur le matériel brouilleur: “Appareils Numériques”, NMB-003 édictée par le ministre des Communications).

NOTICE: The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational and safety requirements. The Department does not guarantee the equipment will operate to the user's satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. In some cases, the inside wiring associated with a single line individual service may be extended by means of a certified connector assembly. The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.

CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate.

UL Notices

The Aurorean Network Gateway-1102/1105 have been tested and found to comply with the UL 1950/CSA c22.2 Revision 3/CUL regulation.

European Notices

The ANG-1102/1105 has been tested and found to comply with the CISPR 22:1997 Class B regulation.

Aurorean Network Gateway-1100 User’s Guide

iii

Image 3
Contents Aurorean Virtual Network ANG-1100 User’s GuideAurorean Network Gateway-1100 User’s Guide Iii Important Safety Instructions Table of Contents Table of Contents Configuring the ANG-1100 with Aurorean WebUnited States Government Restricted Rights Page About This Guide Contents of the GuideConventions Used in This Guide About This Guide Related Publications Related PublicationsPage System Description OverviewSystem Description ANG-1102/1105 TopologyUnpacking the ANG-1102/1105 InstallationAccessories Location PlanningUnpacking the ANG-1102/1105 Chapter Connecting Cables Connecting CablesEthernet Connections Do one of the following as shown in Figure ANG-3000/7000Aurorean Network Serial Connection Reset TER NALConnecting Power to the ANG-1102/1105 Chapter Connecting Power to the ANG-1102/1105Connecting Power to the ANG-1102/1105 Connecting the Power Cable to the Power SupplyChecking ANG-1102/1105 Connections LED behaviorChecking ANG-1102/1105 Connections Chapter Before You Begin Configuring the ANG-1100 with Aurorean Web ConfigConfiguring the ANG-1100 with Aurorean Web Config VPN Status window appears as shown in Figure Logging into Web ConfigTo log into Web Config, perform the steps below Login window appears as shown in FigureSet Password Setting Your PasswordClick the Set Password menu option Set Password window appears as shown in FigureVPN Status Viewing VPN StatusSetting Up the VPN Click the VPN Setup menu optionVPN Setup window appears as shown in Figure Assigned VPN Connections Aurorean Network Gateway VPN SetupSelect one of the following Connection modes Click Apply Setting Up the Internet Connection Click the Internet Setup menu optionInternet Setup window appears as shown in Figure Internet Setup Internet Setup Window Do one of the followingConfiguring the ANG-1100 with Aurorean Web Config Firmware Update Click the Firmware Upgrade menu optionFirmware Upgrade window appears as shown in Figure Firmware Update window appears as shown in FigureSecond Firmware Update Window Image Date and Build Information Aurorean Network Gateway Firmware UpdateLAN Setup Setting Up the LANClick the LAN Setup menu option LAN Setup window appears as shown in FigureConfiguring the ANG-1100 with Aurorean Web Config Setting Up the Firewall Firewall Setup Begin Firewall Setup by performing the following stepsClick the Firewall Setup menu option Firewall Setup window appears as shown in FigureSetting Your Password Set Password Window Checking Device Status Click the Device Status menu optionDevice Status window appears as shown in Figure Device Status Window System Log Network DevicesRoute Table InterruptsUsing Advanced Utilities Advanced Utilities window appears as shown in FigureAdvanced Utilities Using the Configuration Editor Configuration Edit window appears as shown in Figure Click the Configuration Edit menu optionConfiguring the ANG-1100 with Aurorean Web Config Configuring IP Port Forwarding Follow the steps below to configure IP port forwarding Switch Arg DefinitionUsage Example Page Aurorean Policy Server Aurorean Web ConfigGlossary Aurorean Network GatewayFirewall EthernetIP Security Protocol IPSec Internet Service Provider ISPGeneric Routing Encapsulation GRE IP AddressNetwork Address Translation NAT Network Administrator LEDsMac Address PPPoE Point of Presence POPPoint-to-Point Protocol PPP Point-to-Point Tunneling Protocol PptpRouters TunnelingVirtual Private Network VPN Specifications This appendix details the specifications of the ANG-1100Category Parameters Specifications Vcci Page Pin Assignments Ethernet Port Pin Assignments Pin SignalSerial Port Pin Assignments DB-9Page Enterasys Networks, Inc. Program License Agreement Program License Agreement SupportExport Requirements LicenseOther Restrictions Applicable LawExclusion of Warranty United States Government Restricted RightsUnited States Government Restricted Rights No Liability for Consequential Damages Technical SupportSupport from Enterasys Networks Technical Support Returning Products for RepairPage VPN LED IndexLAN IndexPOP Index