C
Pin Assignments
This appendix describes pin assignments for the Ethernet connectors on the ANG-1100. Additionally, the ANG-1105 provides a serial connector.
ANG-1100 servers are equipped with either two or five Ethernet ports located at the rear of the chassis, supporting full-duplex 10Base-T transmission. Connections from your PC to the ANG-1105 require the use of a straight- through cable (not supplied); PC connections to the ANG-1102 require a crossover cable or a straight-through cable if using a hub.
Both Ethernet port types conform to IEEE 802.3 standards with 8-pin modular RJ-45 connectors. Figure 1 shows the pin assignments for ANG-1100 server Ethernet ports.
Replacement Ethernet cables must meet the following requirements:
!Category 3, 4, or 5 unshielded twisted-pair (UTP) wiring
!Length cannot exceed 328 feet (100 meters)
Aurorean Network Gateway-1100 User’s Guide | 51 |