Enterasys Networks ANG-1100 manual Specifications

Page 62

Appendix B

Specifications

Table 1 ANG-1100 Specifications (Continued)

Category		Parameters

Performance	Server Capacity	> 25 concurrent tunnels

	Tunnel	Up to 3 Mbps with IPSec
	Performance

	Hardware	SafeNet 1140 CryptoCore chip on ANG-1105
	acceleration

Protocols &	Tunnel Protocols	IP Security Protocol (IPSec) as defined in RFC 2401 and 2409
Standards		Point-to-Point Tunneling Protocol (PPTP) as defined in
		RFC 1234
		Generic Routing Encapsulation (GRE) as defined in RFC 1701
		and 1702
		Internet Key Exchange (IKE)
		PPP over Ethernet (PPPOE)

	Encapsulated	IP
	LAN Protocols

	Routing Protocols	RIP V1, V2
		Support for dynamic Virtual Network addressing, local network
		addressing, or static routes

	Authentication	HMAC SHA1 and MD5
		Challenge Handshake Authentication Protocol (CHAP)
		MS-CHAP (Microsoft proprietary version of CHAP)

	Encryption	MPPE, 40- and 128-bit configurable keys (RC4-compatible)
		IPSec, 40- and 128-bit configurable keys (RC-4 compatible)
		DES (56-bit) or Triple-DES (168-bit) with IPSec only

	Compression	Microsoft Point-to-Point Compression (MPPC)

	Firewall support	Port filtering and packet inspection firewall

		NAT Gateway to mask internal device addresses

	Other	DHCP Server

Operating	Type	Version of Linux (uClinux 2.04)
System

48	Aurorean Network Gateway-1100 User’s Guide

Image 62

Contents ANG-1100 User’s Guide Aurorean Virtual NetworkAurorean Network Gateway-1100 User’s Guide Iii Important Safety Instructions Table of Contents Configuring the ANG-1100 with Aurorean Web Table of ContentsUnited States Government Restricted Rights Page Contents of the Guide About This GuideConventions Used in This Guide Related Publications About This Guide Related PublicationsPage Overview System DescriptionANG-1102/1105 Topology System DescriptionInstallation Unpacking the ANG-1102/1105Unpacking the ANG-1102/1105 Chapter AccessoriesLocation Planning Ethernet Connections Connecting CablesConnecting Cables Aurorean Network Do one of the following as shown in FigureANG-3000/7000 Reset TER NAL Serial ConnectionConnecting Power to the ANG-1102/1105 Connecting Power to the ANG-1102/1105 ChapterConnecting the Power Cable to the Power Supply Connecting Power to the ANG-1102/1105Checking ANG-1102/1105 Connections Chapter Checking ANG-1102/1105 ConnectionsLED behavior Configuring the ANG-1100 with Aurorean Web Config Before You BeginConfiguring the ANG-1100 with Aurorean Web Config Login window appears as shown in Figure Logging into Web ConfigTo log into Web Config, perform the steps below VPN Status window appears as shown in FigureSet Password window appears as shown in Figure Setting Your PasswordClick the Set Password menu option Set PasswordViewing VPN Status VPN StatusVPN Setup window appears as shown in Figure Setting Up the VPNClick the VPN Setup menu option Aurorean Network Gateway VPN Setup Assigned VPN ConnectionsSelect one of the following Connection modes Click Apply Internet Setup window appears as shown in Figure Setting Up the Internet ConnectionClick the Internet Setup menu option Internet Setup Window Do one of the following Internet SetupConfiguring the ANG-1100 with Aurorean Web Config Firmware Update window appears as shown in Figure Click the Firmware Upgrade menu optionFirmware Upgrade window appears as shown in Figure Firmware UpdateSecond Firmware Update Window Aurorean Network Gateway Firmware Update Image Date and Build InformationLAN Setup window appears as shown in Figure Setting Up the LANClick the LAN Setup menu option LAN SetupConfiguring the ANG-1100 with Aurorean Web Config Setting Up the Firewall Firewall Setup window appears as shown in Figure Begin Firewall Setup by performing the following stepsClick the Firewall Setup menu option Firewall SetupSetting Your Password Set Password Window Device Status window appears as shown in Figure Checking Device StatusClick the Device Status menu option Device Status Window Interrupts Network DevicesRoute Table System LogAdvanced Utilities Using Advanced UtilitiesAdvanced Utilities window appears as shown in Figure Using the Configuration Editor Click the Configuration Edit menu option Configuration Edit window appears as shown in FigureConfiguring the ANG-1100 with Aurorean Web Config Configuring IP Port Forwarding Usage Follow the steps below to configure IP port forwardingSwitch Arg Definition Example Page Aurorean Network Gateway Aurorean Web ConfigGlossary Aurorean Policy ServerEthernet FirewallIP Address Internet Service Provider ISPGeneric Routing Encapsulation GRE IP Security Protocol IPSecMac Address Network Address Translation NAT Network AdministratorLEDs Point-to-Point Tunneling Protocol Pptp Point of Presence POPPoint-to-Point Protocol PPP PPPoEVirtual Private Network VPN RoutersTunneling Category Parameters SpecificationsThis appendix details the specifications of the ANG-1100 Specifications Vcci Page Pin Assignments Pin Signal Ethernet Port Pin AssignmentsDB-9 Serial Port Pin AssignmentsPage Program License Agreement Support Enterasys Networks, Inc. Program License AgreementApplicable Law LicenseOther Restrictions Export RequirementsUnited States Government Restricted Rights Exclusion of WarrantyUnited States Government Restricted Rights Support from Enterasys Networks No Liability for Consequential DamagesTechnical Support Returning Products for Repair Technical SupportPage Index VPN LEDIndex LANPOP Index