Enterasys Networks ANG-1100 manual Click Apply

Chapter 3

Configuring the ANG-1100 with Aurorean Web Config

9Optional. Check the Start network gateway now checkbox and click Apply to create instant access or wait until the other end of the connection is created.

10Optional. Click Force default route under Global VPN Settings.

Force default route disables the ANG-1100’s Intelligent Client Routing (ICR) feature which allows users to browse the Internet outside the tunnel. Be aware that with Force Default enabled, the ANG-1100 transmits all traffic through the tunnel which may cause Web browsing problems. This feature works with only one tunnel up and running; it is disabled if you create more than one tunnel.

11Click Apply.

After applying your changes, a VPN Setup update window appears displaying configuration revisions.

NOTE

Now that you have set up a site-to-site connection, configuration is complete unless you want to change the default Internet, LAN, Firewall, Password default values or your service is a Digital Subscriber Line (DSL) which requires that you configure a PPPoE connection (refer to “Setting Up the Internet Connection” on page 20). Some cable internet providers also require that you specify a MAC address (refer to “Using Advanced Utilities” on page 35 for more information).

NOTE

If you press the Reset button after configuring your ANG-1100, you will lose your entire configuration. Any settings you supplied must then be re-entered. Do not use the Reset button unless you want the configuration to return to factory defaults. Also, you may want to record your settings.

Aurorean Network Gateway-1100 User’s Guide 19