Dialogic TX4000 PCI SS7 Configuring the hardware, Configuring H.100 bus termination

Page 17

TX 4000 PCI SS7 Network Interface Board Installation Manual

Installing the TX 4000 board

Configuring the hardware

This topic describes the following procedures for configuring the TX 4000 board:

Configuring H.100 bus termination

Configuring SS7 Monitor mode

DIP switch S1

Configuring H.100 bus termination

The TX 4000 board connects to an H.100 bus. Boards on the H.100 bus are connected to one another with an H.100 bus cable. Enable bus termination on the board located on each end of the H.100 bus.

The following illustration shows the H.100 bus configuration:

H.100 bus cable

Enable bus termination

Enable bus termination

DIP switch S2 on the TX 4000 board controls the H.100 bus termination. The DIP switch is located on the front of the board, below the H.100 bus connector. By default, all S2 switches are set to the OFF position. H.100 bus termination is disabled.

To enable H.100 bus termination, set all S2 switches to the ON position only for the boards that are on the ends of the H.100 bus.

Note: The switches in DIP switch S2 must be set to either all ON or all OFF.

Dialogic Corporation

17

Image 17
Contents July Copyright and legal notices Revision Release date Revision historyPage Table Of Contents Hardware specifications Current terminology IntroductionPage Board TX 4000 board featuresOverview of the TX TX 4000 board provides PCI bus connectivity Software components Utility Description Utilities and demonstration programsProgram Demonstrates how to Page System requirements Installing the TX 4000 boardStep Description For details, refer to Installation summaryConfiguring H.100 bus termination Configuring the hardwareConfiguring SS7 Monitor mode DIP switch S1 Step Action Installing the boardDirectory Configuring the TX 4000 boardUsing the configuration utility Txcpcfg Assigning a CP numberAdding a board Changing a CP number Txcpcfg bus slot updatedCPnumberMoving a board Removing a board # Command Bus Slot CP Number Txcpcfg Saving configuration changesPage Establishing network Connectors and cablesConnections Dialogic MD1 RJ-45 interfaceEthernet interfaces Dual T1/E1 120 ohm adapter cableConnecting to the network T1 network considerations E1 network considerationsTesting in loopback mode TDM configuration Connecting TX boards for redundancyIP network configuration Single-node redundant signaling serverDual-node redundant signaling server External connection status LEDs Verifying the installationOff Trunk has not been configured Following table describes the functionality of each LED Ethernet LEDsBoard status LEDs Boot code LedsStatus LEDs Color Status when illuminated NumberVerifying the board installation Page General hardware specifications Hardware specificationsFeature Specification PhysicalCompliant interface Power requirementsEnvironment Software environmentDSX-1 telephony interface Cept E1 G.703 telephony interfacePage Index Sigtran