Dialogic TX4000 PCI SS7 installation manual DIP switch S1

Page 19

TX 4000 PCI SS7 Network Interface Board Installation Manual

Installing the TX 4000 board

DIP switch S1

DIP switch S1 controls the operation of the board. By default, only switch 2 (AUTOSTART) is set to the ON position; all other S1 switches are set to the OFF position. Switch 5 is reserved for future use. Do not modify the default settings for this switch.

Set switch 8 (SW MIN BOOT) to ON to boot the board to the original software image instead of using the current production software image. This allows for recovery from any condition that resulted in the corruption of the production software image. After setting this switch to ON, use txreset to boot the backup software image, and then use txflash to burn a clean copy of the production image. Once the production image is completely transferred to the board's flash memory, turn this switch to OFF, and issue txreset to boot the board using the newly loaded production software image.

Dialogic Corporation

19

Image 19

Contents July Copyright and legal notices Revision Release date Revision historyPage Table Of Contents Hardware specifications Current terminology IntroductionPage Overview of the TX TX 4000 board featuresBoard TX 4000 board provides PCI bus connectivity Software components Utility Description Utilities and demonstration programsProgram Demonstrates how to Page System requirements Installing the TX 4000 boardStep Description For details, refer to Installation summaryConfiguring H.100 bus termination Configuring the hardwareConfiguring SS7 Monitor mode DIP switch S1 Step Action Installing the boardUsing the configuration utility Configuring the TX 4000 boardDirectory Txcpcfg Assigning a CP numberAdding a board Changing a CP number Txcpcfg bus slot updatedCPnumberMoving a board Removing a board # Command Bus Slot CP Number Txcpcfg Saving configuration changesPage Dialogic MD1 RJ-45 interface Connectors and cablesEstablishing network ConnectionsEthernet interfaces Dual T1/E1 120 ohm adapter cableConnecting to the network T1 network considerations E1 network considerationsTesting in loopback mode TDM configuration Connecting TX boards for redundancyIP network configuration Single-node redundant signaling serverDual-node redundant signaling server Off Trunk has not been configured Verifying the installationExternal connection status LEDs Following table describes the functionality of each LED Ethernet LEDsBoard status LEDs Boot code LedsStatus LEDs Color Status when illuminated NumberVerifying the board installation Page Physical Hardware specificationsGeneral hardware specifications Feature SpecificationSoftware environment Power requirementsCompliant interface EnvironmentDSX-1 telephony interface Cept E1 G.703 telephony interfacePage Index Sigtran