Dialogic TX4000 PCI SS7 installation manual TX 4000 board provides PCI bus connectivity

Page 10

Overview of the TX 4000 board

TX 4000 PCI SS7 Network Interface Board Installation Manual

The following illustration shows the TX 4000 board:

Ethernet

T1/E1 trunk

T1/E1

status

connectors

connectors

LEDs

 

 

Ethernet

MAC/PHY

chips

S3 DIP

switch

Framer

Host

bridge

PCI to 60x

bridge

8260 Power

QUICC II controller

T8100A

H.100

interface

The TX 4000 board provides:

PCI bus connectivity

PCI to MPX

bridge

7457 RISC

microprocessor

with fan

H.100 bus connector

S2 DIP switch

Each board is designed to reside in a single PCI bus slot. Each board contains a universal (5.0 V or 3.3 V signaling) PCI bus interface that is compliant with the PCI Local Bus Specification, Revision 2.2. The PCI interface is a 33/66 MHz, 32- bit master/target device.

H.100 bus connectivity

The TX 4000 board fully supports the H.100 bus specification. The H.100 bus enables boards to share data and signaling information with other boards on the H.100 bus. For example, you can connect two or more TX 4000 boards for applications that perform trunk-to-trunk switching. In addition, you can use H.100 compatible products from other manufacturers with the TX 4000 board.

The H.100 interface supports a full mode stream configuration on the H.100 bus with 32 streams at 8 MHz each. Each stream provides 128 timeslots for a total of 4096 timeslots.

10

Dialogic Corporation

Image 10
Contents July Copyright and legal notices Revision history Revision Release datePage Table Of Contents Hardware specifications Introduction Current terminologyPage Overview of the TX TX 4000 board featuresBoard TX 4000 board provides PCI bus connectivity Software components Utilities and demonstration programs Utility DescriptionProgram Demonstrates how to Page Installing the TX 4000 board System requirementsInstallation summary Step Description For details, refer toConfiguring the hardware Configuring H.100 bus terminationConfiguring SS7 Monitor mode DIP switch S1 Installing the board Step ActionUsing the configuration utility Configuring the TX 4000 boardDirectory Assigning a CP number TxcpcfgAdding a board Txcpcfg bus slot updatedCPnumber Changing a CP numberMoving a board Removing a board Saving configuration changes # Command Bus Slot CP Number TxcpcfgPage Connections Connectors and cablesEstablishing network Dialogic MD1 RJ-45 interfaceDual T1/E1 120 ohm adapter cable Ethernet interfacesConnecting to the network E1 network considerations T1 network considerationsTesting in loopback mode Connecting TX boards for redundancy TDM configurationSingle-node redundant signaling server IP network configurationDual-node redundant signaling server Off Trunk has not been configured Verifying the installationExternal connection status LEDs Ethernet LEDs Following table describes the functionality of each LEDBoot code Leds Board status LEDsColor Status when illuminated Number Status LEDsVerifying the board installation Page Feature Specification Hardware specificationsGeneral hardware specifications PhysicalEnvironment Power requirementsCompliant interface Software environmentCept E1 G.703 telephony interface DSX-1 telephony interfacePage Index Sigtran