Dialogic TX4000 PCI SS7 Ethernet LEDs, Following table describes the functionality of each LED

Page 38

Verifying the installation

TX 4000 PCI SS7 Network Interface Board Installation Manual

Ethernet LEDs

The TX 4000 board provides two LEDs to indicate the status of each Ethernet interface. The LEDs are located in the RJ-45 connectors as shown in the following illustration:

Ethernet 1 LIN K/AC T LED (green)

Ethernet 1 1 00 LED (green)

Eth e rne t 2 LIN K/AC T LED (green)

E th e r n e t 2 10 0 LED (green)

The following table describes the functionality of each LED:

LED

Description

 

 

LINK/ACT

Indicates the status of the Ethernet link. When the Ethernet link has established link integrity, the LED is on and steady. It also indicates the transmitting and receiving activity on the link. When activity is present on the Ethernet link, the LED flickers.

100

Indicates the data rate of the Ethernet link. When the LED is on, the data rate is 100 Mb. When the LED is off, the data rate is 10 Mb. The LED is used only when a reliable Ethernet connection has been established. (The LINK/ACT LED is on.)

38

Dialogic Corporation

Image 38
Contents July Copyright and legal notices Revision history Revision Release datePage Table Of Contents Hardware specifications Introduction Current terminologyPage Board TX 4000 board featuresOverview of the TX TX 4000 board provides PCI bus connectivity Software components Utilities and demonstration programs Utility DescriptionProgram Demonstrates how to Page Installing the TX 4000 board System requirementsInstallation summary Step Description For details, refer toConfiguring the hardware Configuring H.100 bus terminationConfiguring SS7 Monitor mode DIP switch S1 Installing the board Step ActionDirectory Configuring the TX 4000 boardUsing the configuration utility Assigning a CP number TxcpcfgAdding a board Txcpcfg bus slot updatedCPnumber Changing a CP numberMoving a board Removing a board Saving configuration changes # Command Bus Slot CP Number TxcpcfgPage Connections Connectors and cablesEstablishing network Dialogic MD1 RJ-45 interfaceDual T1/E1 120 ohm adapter cable Ethernet interfacesConnecting to the network E1 network considerations T1 network considerationsTesting in loopback mode Connecting TX boards for redundancy TDM configurationSingle-node redundant signaling server IP network configurationDual-node redundant signaling server External connection status LEDs Verifying the installationOff Trunk has not been configured Ethernet LEDs Following table describes the functionality of each LEDBoot code Leds Board status LEDsColor Status when illuminated Number Status LEDsVerifying the board installation Page Feature Specification Hardware specificationsGeneral hardware specifications PhysicalEnvironment Power requirementsCompliant interface Software environmentCept E1 G.703 telephony interface DSX-1 telephony interfacePage Index Sigtran