Dialogic TX4000 PCI SS7 installation manual Overview of the TX, Board, TX 4000 board features

Page 9

2	Overview of the TX 4000
	board

TX 4000 board features

The Dialogic® TX 4000 PCI SS7 Network Interface board is a PCI board that provides four T1 or E1 digital trunk interfaces and two Ethernet 10/100Base-T interfaces. The TX 4000 design is based on an intelligent communication processor (CP) that plugs into a single PCI bus slot. The CP operates with the PCI bus host processor to form a distributed communications application platform.

The CP features one high-performance Motorola MPC7457 RISC microprocessor and one MPC8260 PowerQUICC II controller with a 32-bit PCI bus interface. Dialogic® NaturalAccess™ Signaling Software packages provide programming capabilities for the TX 4000 board CP.

Dialogic Corporation

9

Image 9

Contents July Copyright and legal notices Revision Release date Revision historyPage Table Of Contents Hardware specifications Current terminology IntroductionPage TX 4000 board features Overview of the TXBoard TX 4000 board provides PCI bus connectivity Software components Utility Description Utilities and demonstration programsProgram Demonstrates how to Page System requirements Installing the TX 4000 boardStep Description For details, refer to Installation summaryConfiguring H.100 bus termination Configuring the hardwareConfiguring SS7 Monitor mode DIP switch S1 Step Action Installing the boardConfiguring the TX 4000 board Using the configuration utilityDirectory Txcpcfg Assigning a CP numberAdding a board Changing a CP number Txcpcfg bus slot updatedCPnumberMoving a board Removing a board # Command Bus Slot CP Number Txcpcfg Saving configuration changesPage Establishing network Connectors and cablesConnections Dialogic MD1 RJ-45 interfaceEthernet interfaces Dual T1/E1 120 ohm adapter cableConnecting to the network T1 network considerations E1 network considerationsTesting in loopback mode TDM configuration Connecting TX boards for redundancyIP network configuration Single-node redundant signaling serverDual-node redundant signaling server Verifying the installation Off Trunk has not been configuredExternal connection status LEDs Following table describes the functionality of each LED Ethernet LEDsBoard status LEDs Boot code LedsStatus LEDs Color Status when illuminated NumberVerifying the board installation Page General hardware specifications Hardware specificationsFeature Specification PhysicalCompliant interface Power requirementsEnvironment Software environmentDSX-1 telephony interface Cept E1 G.703 telephony interfacePage Index Sigtran