Wireway Installation | Eaton Electrical BladeUPS Bar specification

INSTALLATION

Rear of Rack

Side Bracket Adjustment Screws

(3 places each side)

Adjustable Side Brackets (1 each side)

4.Install an M6 hex nut onto each of the three wireway studs to secure the wireway to the rear of the rack. Install the first stud in the fourth hole location from the bottom. Do not tighten the nuts. Figure 4 shows the nuts installed.

5.Loosen the three adjustment screws on each side of the wireway housing and adjust the side brackets for the depth of the rack. Do not retighten the screws.

6.Install six M6×12 pan-head screws and M6 split lock washers to secure the two wireway side brackets to the front of the rack. Install the first screws in the fifth hole location from the bottom. Torque the screws to 5.1 ± 0.8 Nm (45 ± 7 lb in).

7.Tighten the three M6 hex nuts installed in Step 4. Torque the nuts to 5.1 ± 0.8 Nm (45 ± 7 lb in).

8.Retighten the six side bracket adjustment screws loosened in Step 5. Torque to 3.4 Nm (30 lb in).

M6 Hex Nuts on Wireway Studs

(3 places)

Wireway

Housing

M6×12 Pan-Head Screws and M6 Split Lock Washers

(3 places each side)

Front of Rack

Figure 3. Wireway Installation

8	EATON Powerware® BladeUPS® Bar Installation Guide S 164201723 Rev P01