Eaton Electrical BladeUPS Bar manual Wireway Access Cover Installation

Page 18

INSTALLATION

19.Using five M4×8 pan-head screws, install the wireway access cover. See Figure 9. Torque the screws to 1.7 ± 0.2 Nm

(15 ± 2 lb in).

M4×8 Pan-Head Screws (5 places)

Wireway Access Cover

Figure 9. Wireway Access Cover Installation

20.Verify the six information labels are attached to the wireway as shown in Figure 10.

Figure 10. Wireway Labels

14

EATON Powerware® BladeUPS® Bar Installation Guide S 164201723 Rev P01

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Powerware BladeUPS Bar Installation Guide Special Symbols Table of Contents Table of Contents Chapter Introduction Consignes DE Sécurité Importantes Conserver CES Instructions Wichtige Sicherheitsanweisungen Aufbewaren Viktiga Säkerhetsföreskrifter Spara Dessa Föreskrifter Chapter Installation Checking the Package Contents U T I O N Wireway Installation Ferrite and Bar Placement Bar Base Installation Bar Bracket Installation Wireway Tab Attachment Wireway Terminal Block Housing Installation Wireway Access Cover Installation Front Cover Mounting Panel Installation Snap the two front covers into place, as shown in Figure Chapter Specifications Specifications Service and Support Service and Support Page Page Page 164201723P01
Top Page Image Contents