Cyclades PM IPDU manual Adduser, Syntax, Arguments, Examples

Chapter 4: Command Line Interface 33

The following commands are available only to the admin user.

Table 4.2: Admin User (privileged) Commands

Admin User Command	Admin User Command
adduser on page 33	hwocp on page 44
alarm on page 34	id on page 45
assign on page 34	name on page 48
buzzer on page 35	reboot on page 51
currentprotection on page 36	restore on page 53
dbsync on page 39	save on page 53
deluser on page 39	syslog on page 55
display on page 40	unassign on page 57
factory_defaults on page 41	upgrade on page 58

NOTE: When a range of outlets is used in a command and the range spans more than one PM IPDU in a daisy chain, the range of outlets must not be specified by name. The range of outlets may only be specified by number in this situation.

adduser

The adduser command adds one username to the internal database. A maximum of eight characters (not case sensitive) is allowed, and a maximum of eight individual users is allowed. This command is available to the admin user only.

Syntax

adduser <user>

Arguments

<user> username

Examples

To add a user, enter the following.

pm>adduser popper

Password:

Re-enter password:

Username/password set for user popper.

pm>