Bay Technical Associates 5218H, 528H, 529H, 525H owner manual Enter Port Number 0=Exit,Return

Status	1
Set Serial Port Configuration	2
Set Message Terminate Character	3
Set Data Block Length	4
Set Control Character	5
Set Mode of Operation	6
Exit	X
Enter Request:

NOTE: "n" shown on the previous page indicates single-digit port numbers on the 525H and 528H. The menus of the 5218H will display nn indicating two-digit port numbers.

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

By responding to the Enter Request: message at the end of the main configuration menu (see Section 6.1) with "2" (Set Serial Port Configuration), you may change the configuration of each port (i.e. baud rate, word size, stop bits, parity and XON/XOFF handshaking). Note that each port is configured individually. The multiport will respond with:

Enter Port Number (0=Exit),Return:

You should then enter the number of the port that you wish to reconfigure, followed by Carriage Return. Note that if 0 (zero) is entered, you will exit back to the main configuration menu.

For example, if you enter "3" and Carriage Return for Port 3, the multiport will respond with the current status of Port 3 and a menu of the available options:

•••••••••••••••••••••••••••••••••••••••••

•	Port •	Baud	•	Word	•	Stop	•Parity•Xon/•
•	•	Rate	•	Size	•	Bits	•	•Xoff•

•••••••••••••••••••••••••••••••••••••••••

•3 • 9600 • 8 • 1 • None • Off•

•••••••••••••••••••••••••••••••••••••••••

Exit/Save			1	Set stop bits....		4
Set	baud	rate	2	Set	parity	5
Set	word	size	3	Set	Xon/Xoff	6

Enter request: