Bay Technical Associates 528H, 5218H, 529H, 525H owner manual Mode of Operation

Page 37

￿￿! ￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

By responding to the Enter Request: message at the end of the main configuration menu (see Section 6.1) with "6" (Set Mode of Operation), you may change the current mode of operation. The multiport will respond with:

MODE OF OPERATION

 

Full Duplex Communication

1

All Messages from All Ports

2

Single Message from All Ports

3

All Messages from Selected Port

4

Single Message from Selected Port

5

Time Division Multiplexer

6

Exit

X

Current Mode is: 1

 

Enter request:

 

You may now enter the mode of operation that you wish. The multiport will respond with:

Save Changes Permanently? (Y/N):

If you answer "Y" (yes), the new mode will be saved in non-volatile memory and will become the new power-up mode. If you answer "N" (no), the new mode of operation will be stored in RAM and will be lost upon next power-up. The multiport will now return to the main configuration menu (see Section 6.1).

￿￿￿"￿￿

By responding to the Enter Request: message at the end of the main configuration menu (see Section 6.1) with capital "X" (Exit), you will exit the configuration mode and return to the operation mode.

32

Page 36 Page 38
Image 37
Page 36 Page 38
Contents Series Multiport Controllers Page Copyright 1993 by Bay Technical Associates, Inc Table of Contents Federal Communications Commission Radio Frequency Page Page Below shows six applications, one for each mode of operation USER-PROGRAMMABLE Configurations Factory POWER-UP Default ConfigurationsUL and CSA Listed Page Page Page DCE Port Signals 500H Series DCE to DTE Device Page Factory default is Carriage Return 0D Hex Page Page Page Page Page Page Page Page Host-to-multiport-to-peripheral communication Peripheral-to-multiport-to-host communication Host-to-multiport-to-peripheral communication Peripheral-to-multiport-to-host communication Page Operation Protocol Enter Port Number 0=Exit,Return For 110 135 300 600 1200 2400 4800 9600 Enter request 0AH Section Control Mode of Operation Main Menu SET Message Terminate Character TITC22*233343526Y130A4250*51466X Page Page Page Solutions Problem Garbage Data Symptom Missing Characters Symptom Random Garbage Characters Problem Cant Select Peripheral Port from Host Device Problem Cant Receive Data from Peripheral Ports Ccitt DOS Page Page Page Uart Other Baytech Products Page Page Series Multiport Controllers Page
Top Page Image Contents