Bay Technical Associates 5218H, 528H, 529H, 525H owner manual TITC22*233343526Y130A4250*51466X

Page 40

For example, to configure Port 2 in the non-verbose mode at 300 baud rate, 7 bit word size, 2 stop bits, even parity, XON/XOFF enabled, line feed terminating character, data block length 250, control character Control-T, mode of operation 6, and XON/XOFF enabled, send the following character string:

^TI^TC22*233343526Y130A4250*51466X.

This breaks down as follows:

^T indicates control character.

Iindicates non-verbose mode. ^T indicates control character. C indicates Configuration Mode.

2 indicates Set Serial Port Configuration.

2 indicates Port 2.

* indicates Carriage Return.

2 indicates Set Baud Rate.

3 indicates 300 Baud.

3 indicates Set Word Size.

3 indicates 7 Word Size.

4 indicates Set Stop Bits.

3 indicates 2 Stop Bits.

5 indicates Set Parity.

2 indicates Even Parity.

6 indicates Set XON/XOFF.

Y indicates XON/XOFF enabled.

1 indicates Exit to Main Menu.

3 indicates Set Message Terminate Character.

0A indicates Line Feed Terminating Character in Hex.

4 indicates Set Data Block Length.

250 indicates Data Block Length. * indicates Carriage Return.

5 indicates Set Control Character.

14 indicates Control-Tin HEX.

6 indicates Set Mode of Operation.

6 indicates Mode of Operation 6.

X indicates Exit to Operation Mode.

Image 40
Contents Series Multiport Controllers Page Copyright 1993 by Bay Technical Associates, Inc Table of Contents Federal Communications Commission Radio Frequency Page Page Below shows six applications, one for each mode of operation Factory POWER-UP Default Configurations USER-PROGRAMMABLE ConfigurationsUL and CSA Listed Page Page Page DCE Port Signals 500H Series DCE to DTE Device Page Factory default is Carriage Return 0D Hex Page Page Page Page Page Page Page Page Host-to-multiport-to-peripheral communication Peripheral-to-multiport-to-host communication Host-to-multiport-to-peripheral communication Peripheral-to-multiport-to-host communication Page Operation Protocol Enter Port Number 0=Exit,Return For 110 135 300 600 1200 2400 4800 9600 Enter request 0AH Section Control Mode of Operation Main Menu SET Message Terminate Character TITC22*233343526Y130A4250*51466X Page Page Page Solutions Problem Garbage Data Symptom Missing Characters Symptom Random Garbage Characters Problem Cant Select Peripheral Port from Host Device Problem Cant Receive Data from Peripheral Ports Ccitt DOS Page Page Page Uart Other Baytech Products Page Page Series Multiport Controllers Page