Bay Technical Associates 525H, 5218H, 528H, 529H owner manual Section

Page 35

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

By responding to the Enter Request: message at the end of the main configuration menu (see Section 6.1) with "4" (Set Data Block Length), you may change the data block length used in Mode 6.

The multiport will respond with:

Current Block Length is

032

Enter Block Length (1 to 250)

:

NOTE: Carriage Return is required after the new length.

Enter the block length that you desire, followed by Carriage Return. For example, if you enter "100" and Carriage Return, the multiport will respond with:

Current Block Length is

100

Save Changes Permanently? (Y/N):

 

If you answer "Y" (yes), the new block length will be saved in non-volatile memory, and the multiport will subsequently power-up at that new length. If you answer "N" (no), the new data block length will be stored in RAM and will be lost upon next power-up. The multiport will now return to the main configuration menu (see

Section 6.1).

30

Page 34 Page 36
Image 35
Page 34 Page 36
Contents Series Multiport Controllers Page Copyright 1993 by Bay Technical Associates, Inc Table of Contents Federal Communications Commission Radio Frequency Page Page Below shows six applications, one for each mode of operation USER-PROGRAMMABLE Configurations Factory POWER-UP Default ConfigurationsUL and CSA Listed Page Page Page DCE Port Signals 500H Series DCE to DTE Device Page Factory default is Carriage Return 0D Hex Page Page Page Page Page Page Page Page Host-to-multiport-to-peripheral communication Peripheral-to-multiport-to-host communication Host-to-multiport-to-peripheral communication Peripheral-to-multiport-to-host communication Page Operation Protocol Enter Port Number 0=Exit,Return For 110 135 300 600 1200 2400 4800 9600 Enter request 0AH Section Control Mode of Operation Main Menu SET Message Terminate Character TITC22*233343526Y130A4250*51466X Page Page Page Solutions Problem Garbage Data Symptom Missing Characters Symptom Random Garbage Characters Problem Cant Select Peripheral Port from Host Device Problem Cant Receive Data from Peripheral Ports Ccitt DOS Page Page Page Uart Other Baytech Products Page Page Series Multiport Controllers Page
Top Page Image Contents