Bay Technical Associates 529H, 5218H, 528H, 525H owner manual

Page 30

￿￿￿￿￿￿￿￿￿￿￿￿￿￿

To access the configuration mode of the multiport, connect a dumb terminal (or a PC running a terminal emulation program) to the host port: Port 5 of the 525H, Port 9 of the 528H and 529H, or Port 18 of the 5218H. This port is factory configured at 9600 baud rate, 8 word size, 1 stop bit, no parity, and XON/XOFF disabled.

If you do not have a dumb terminal or a terminal emulation program, BayTech supplies a utility diskette which includes instructions to put an IBM PC or compatible into a dumb terminal mode (see Section 3.2).

Send from this device the control character (factory default is Control-T- 14 Hex) followed by ASCII capital C (43 Hex). The multiport should respond with the main configuration menu as shown in Section 6.1. From this point on, configuration of the multiport will be menu-driven. While in configuration mode, you may send Control-Sto stop scrolling and Control-Qto continue scrolling.

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

The multiport will respond to the receiving of the control character and capital C with an identification block and a configuration menu of the options available, similar to the following for the 528H:

Bay Technical Associates

 

Model 528H Multiport Controller

 

Copyright 1986

 

Revision 2.06

 

Status

1

Set Serial Port Configuration

2

Set Message Terminate Character

3

Set Data Block Length

4

Set Control Character

5

Set Mode of Operation

6

Exit

X

Enter Request:

 

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Series Multiport Controllers Page Copyright 1993 by Bay Technical Associates, Inc Table of Contents Federal Communications Commission Radio Frequency Page Page Below shows six applications, one for each mode of operation Factory POWER-UP Default Configurations USER-PROGRAMMABLE ConfigurationsUL and CSA Listed Page Page Page DCE Port Signals 500H Series DCE to DTE Device Page Factory default is Carriage Return 0D Hex Page Page Page Page Page Page Page Page Host-to-multiport-to-peripheral communication Peripheral-to-multiport-to-host communication Host-to-multiport-to-peripheral communication Peripheral-to-multiport-to-host communication Page Operation Protocol Enter Port Number 0=Exit,Return For 110 135 300 600 1200 2400 4800 9600 Enter request 0AH Section Control Mode of Operation Main Menu SET Message Terminate Character TITC22*233343526Y130A4250*51466X Page Page Page Solutions Problem Garbage Data Symptom Missing Characters Symptom Random Garbage Characters Problem Cant Select Peripheral Port from Host Device Problem Cant Receive Data from Peripheral Ports Ccitt DOS Page Page Page Uart Other Baytech Products Page Page Series Multiport Controllers Page
Top Page Image Contents