Bay Technical Associates 525H, 5218H, 528H, 529H owner manual

Page 43

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿$￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿%

This equipment generates and uses radio frequency energy and, if not installed and used properly (that is, in strict accordance with the manufacturer's instructions) may cause interference to radio and television reception. The equipment has been type tested and found to comply within the limits for a Class A computing device in accordance with the specifications in Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference to radio or television reception will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

1.Reorient the receiving antenna.

2.Relocate the computer equipment with respect to the receiver.

3.Move the computer away from the receiver.

4.Plug the computer into a different outlet so that computer and receiver are on different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The Federal Communications Commission has prepared a booklet entitled "How to Identify and Resolve Radio - TV Interference Problems" which may be helpful to you. This booklet (stock #004-000-00345-4) may be purchased from the Superintendent of Documents, U.S. Government Printing Office, Washington, D.C. 20402.

*Use of a shielded interface cable is required to comply within the Class A limits in Subpart J of Part 15 of FCC rules.

38

Image 43
Contents Series Multiport Controllers Page Copyright 1993 by Bay Technical Associates, Inc Table of Contents Federal Communications Commission Radio Frequency Page Page Below shows six applications, one for each mode of operation USER-PROGRAMMABLE Configurations Factory POWER-UP Default ConfigurationsUL and CSA Listed Page Page Page DCE Port Signals 500H Series DCE to DTE Device Page Factory default is Carriage Return 0D Hex Page Page Page Page Page Page Page Page Host-to-multiport-to-peripheral communication Peripheral-to-multiport-to-host communication Host-to-multiport-to-peripheral communication Peripheral-to-multiport-to-host communication Page Operation Protocol Enter Port Number 0=Exit,Return For 110 135 300 600 1200 2400 4800 9600 Enter request 0AH Section Control Mode of Operation Main Menu SET Message Terminate Character TITC22*233343526Y130A4250*51466X Page Page Page Solutions Problem Garbage Data Symptom Missing Characters Symptom Random Garbage Characters Problem Cant Select Peripheral Port from Host Device Problem Cant Receive Data from Peripheral Ports Ccitt DOS Page Page Page Uart Other Baytech Products Page Page Series Multiport Controllers Page