Bay Technical Associates 5218H, 528H, 529H, 525H owner manual Control

Page 36

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

By responding to the Enter Request: message at the end of the main configuration menu (see Section 6.1) with "5" (Set Control Character), you may change the control character.

WARNING: BayTech advises you to log your new control character. If it is forgotten, you will not be able to control the unit or access the configuration mode.

CONTROL

CHARACTER____________ DATE______ BY___

CONTROL

CHARACTER____________ DATE______ BY___

The multiport will respond with:

Current Control Character is

14H

Enter Control Character in Hex

:

You may now enter the new control character that you want in HEX (00 to 7F Hex). For example, if you enter "15 " (Control-U), the multiport will respond with:

Current Control Character

is

15H

Save Changes Permanently?

(Y/N):

 

If you answer "Y" (yes), the new control character will be saved in non-volatile memory, and the multiport will respond only to that character. The multiport will respond with:

Are You Sure? (Y/N):

This message gives you a second chance to consider this change and reminds you to log your new control character. If you answer either question with "N" (no), the new control character will be stored in RAM and lost upon next power-up. The multiport will return to the main configuration menu (see Section 6.1).

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Series Multiport Controllers Page Copyright 1993 by Bay Technical Associates, Inc Table of Contents Federal Communications Commission Radio Frequency Page Page Below shows six applications, one for each mode of operation Factory POWER-UP Default Configurations USER-PROGRAMMABLE ConfigurationsUL and CSA Listed Page Page Page DCE Port Signals 500H Series DCE to DTE Device Page Factory default is Carriage Return 0D Hex Page Page Page Page Page Page Page Page Host-to-multiport-to-peripheral communication Peripheral-to-multiport-to-host communication Host-to-multiport-to-peripheral communication Peripheral-to-multiport-to-host communication Page Operation Protocol Enter Port Number 0=Exit,Return For 110 135 300 600 1200 2400 4800 9600 Enter request 0AH Section Control Mode of Operation Main Menu SET Message Terminate Character TITC22*233343526Y130A4250*51466X Page Page Page Solutions Problem Garbage Data Symptom Missing Characters Symptom Random Garbage Characters Problem Cant Select Peripheral Port from Host Device Problem Cant Receive Data from Peripheral Ports Ccitt DOS Page Page Page Uart Other Baytech Products Page Page Series Multiport Controllers Page
Top Page Image Contents