DS72 HOST MODULE OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
Enter the module to connect automatically, followed by <cr>. Enter the port to connect automatically, followed by <cr>. The DS72 module stores the new settings in
Toggle Auto Connect Port feature by selecting #2, “Enable/Disable,” from the Auto Connect Port menu followed by <cr>. The DS72 module displays the current auto connect port status and asks if you want to enable. Default
Auto Connect Port is disabled.
Auto Connect is | Disabled |
Type “Y” followed by <cr> if you want to enable Auto Connect Port. Type “N” followed by <cr> if you want to disable Auto Connect Port. Type <cr> for no change. The DS72 module stores Auto Connect Port configuration in
NETWORK PORT | This sets up the network parameters for the DS72. | ||
CONFIGURATION |
|
|
|
| From the configuration menu, select #9, “Network Port Configuration”, | ||
| followed by <cr>. The following menu appears: | ||
| Network Configuration |
| |
| IP Address: | 200.4.2.65 |
|
| Subnet Mask: 255.255.255.0 |
| |
| Gateway: | 200.4.2.1 |
|
| Ethernet Address: 00.C0.48.06.1A.81 | ||
| Connection Inactivity Timeout (mins): 1 | ||
| Carriage Return Translation: Disabled | ||
| Break Length (msecs): 350 |
| |
| IP Address | 1 | |
| Subnet Mask | 2 | |
| Gateway | 3 | |
| Activity Timeout | 4 | |
| Carriage Return Translation | 5 | |
| Break Length | 6 | |
| Exit | X,CR | |
| Enter Request : |
| |
IMPORTANT: For network access, you must configure the IP addresses, Subnet Mask, and Gateway Address. The module must be reset for network changes to take effect.
IP Address | The IP address is the network address assigned by your network manager |
| for your network.The IP Address consist of four bytes, each byte ranging |
| from 0 to 255. This parameter must be programmed before the DS72 |
| may be accessed via the network. |
| From the configuration menu, select #1, “IP Address,” followed by <cr>. |
| The DS72 responds: |
| Enter Module IP address in dotted decimal form: |
18