Bay Technical Associates DS72 owner manual Enter IP address in dotted decimal form

DS72 HOST MODULE OWNER’S MANUAL

DS72 QUICK START

Copyright(C) Bay Technical Associates 1998

DS-72 Data Switch Series - Telnet Host Module

Revision F.1.00

Module 1

Status	1
Serial Port Configuration	2
Port Device Name	3
Port Select Code	4
Attention Character	5
Disconnect Timeguard	6
Connect Port ID Echo	7
Login Setup	8
Network Port Configuration	9
Unit ID	10
Configure Another Module	11
Exit	X,CR

Type “9”, followed by <cr> to access the Network Port Configuration. The following menu is displayed:

Network Configuration

IP Address: 0.0.0.0

Subnet Mask: 0.0.0.0

Gateway: 0.0.0.0

Ethernet Address: 00.C0.48.06.1A.81

Connection Inactivity Timeout (mins): 0

Carriage Return Translation: Disabled

Break Length (msecs): 350

IP Address	1
Subnet Mask	2
Gateway	3
Activity Timeout	4
Carriage Return Translation	5
Break Length	6
Exit	X,CR
Enter Request :

Selections 1 and 2 will allow you to input the address in a dotted decimal format. For example, typing “1”, followed by <cr> will display:

Enter IP address in dotted decimal form :

Enter the address in the following format: nnn.nnn.nnn.nnn where n is any number. If you are unsure of this address, contact your network administrator. The subnet mask and gateway are programmed in a similar fashion. When programming is complete, type “X” followed by <cr>. The system must be reset for these settings to be applicable.

If this is not an initial set-up and password has been enabled, you are prompted to login. After logging in successfully, access the main menu by sending the attention character five times (;;;;;).

4