Subnet Mask, Gateway | Bay Technical Associates DS72 guide

DS72 HOST MODULE OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

Enter the Module IP Address (Example: 200.4.3.50), followed by <cr>. The DS72 resumes the configuration menu.Default Module IP Address is 0.0.0.0.

If you fail to enter the Module IP Address in dotted decimal form, the

DS72 responds again:

Enter Module IP address in dotted decimal form:

The DS72 responds indefinitely with the same request until the Module IP

Address in entered in the correct form.

NOTE: There should be no active connections while configuring the DS72 module. The unit should be reset upon completion of configuration.

Subnet Mask	The Subnet Mask is a bit mask that identifies the network portion of the IP
	address, allowing the DS72 to determine whether to send a packet directly
	to the client or to a gateway. The Subnet Mask consist of four bytes, each
	byte ranging from 0 to 255. This parameter must be programmed
	before the DS-Series can be accessed through the network.
	From the configuration menu, select #2, “Subnet Mask,” followed by
	<cr>. The DS72 responds:
	Enter Subnet Mask in dotted decimal form:
	Enter the Subnet Mask (Example: 255.255.255.0), followed by <cr>. The
	DS72 resumes the configuration menu. Default Subnet Mask is 0.0.0.0.
	If you fail to enter the Subnet Mask in dotted decimal form, the DS72
	responds again:
	Enter Subnet Mask in dotted decimal form:
	The DS72 responds indefinitely with the same request until the Subnet
	Mask is entered in the correct form.
Gateway	The Gateway is the address of a router for connection to their networks.
	The Gateway address consists of four bytes, each byte ranging from 0 to
	255. If your network uses gateways, this parameter must be programmed
	before the DS72 can be accessed through a network.
	From the configuration menu, select #3, “Gateway,” followed by <cr>.
	The DS72 responds:
	Enter Gateway address in dotted decimal form:

Enter the Gateway address (Example: 200.4.5.50), followed by <cr>. The

DS72 resumes the configuration menu. Default Gateway address is

0.0.0.0.If you fail to enter the Gateway address in dotted decimal form, the DS72 responds again:

Subnet Mask