Buffalo Technology WBR2-G54S user manual Advanced Settings

Page 39

Advanced Settings

Wireless Bridge (WDS)

Settings

To enable WDS, set the Wire- less Bridge (WDS) function to Enable.

Enter the Wireless MAC address of the AirStation to communicate with in the form of two characters separated by a colon and click Add.

MAC Address Ex: 00:00:00:00:00:00

Up to six AirStation MAC ad- dresses may be registered.

Click Apply under Wireless Bridge (WDS) settings when the wireless Mac addresses AirStation are entered.

Repeat this process on every other AirStation used in Bridge (WDS) mode.

39

Image 39
Contents WBR2-G54S Table of Contents Network Settings Table of Contents Introduction Introduction SOHO/SMB Networking Home NetworkingSystem Requirements AirStation WBR2-G54S Package ContentsProduct Views About the AirStation CD Installation / Setup Setup Preparation Setup OverviewIntroduction Antenna Installation Open the Setup Screen Standard SettingsEnter ISP information DSL ButtonAutomatic IP Assignment by ISP PPPoE Connection Enter IP Address ManuallyCatv Cable Button Line Test Security Simple Security Setup Applications Refer to the on-screen help for Aoss Aoss Additional Aoss Information Wireless Function Enable or Advanced SettingsLAN Settings Wireless SettingsAdvanced Settings Wireless LAN Security Advanced Settings Characteristics Advanced Settings LAN Port Dhcp Server Advanced Settings Manual IP MAC Address Assignment Settings Wireless PC’s Connection Wireless MAC FilterRegister for Allowable PC’s MAC Address Wireless Bridge WDS Advanced Settings WAN Settings Wired WAN PerformanceWAN Port Connection Type Select from MRU Maximum Receive MTU Maximum TransmitWAN Network Advanced Settings Routing Setup Network SettingsAdd Routing Table Entry Enable or Disable . Address Address TranslationIP Masquerade When Display/Delete NAT Table Add NAT Table Advanced Settings Log Output Select Output to Packet FilterBasic Filter Setting IP Filter Setting MAC Filter Click Enter MAC Lter to enter MAC address Click Apply when settings are complete DETECTOR@AIRSTATION Intrusion DetectorPage UPnP System Information ManagementAdmin Name Password Time setup Select Use or Do not useNTP server name Enter Packet Traffic Information Wired WAN Wired LAN Wireless LANIP Address and Medium Client MonitorPing Test Log Information Display log info SelectLog information Displays Syslog Transfer Log Information LevelLog Information Select Save/Restore Settings Save current settings ClickRestored saved settings Reboot/Reload Defaults Click Restart to rebootAirStation Firmware Update Com/wirelessFirmware file name Client Table Displays AossManually specify the encryp Aoss Function Click EnableAdditional Information Temperature & HumidityPower Characteristics SpecificationsHost Operating System Networking CharacteristicsRadio Characteristics Regulatory InformationOpen Office Environment Semi-Open Office Environment 2412 Diag LED Activity TroubleshootingCommon Problems LED Activity BChanging Client TCP/IP Settings in Windows Table B.1.1 Diag LED Activity TableLEDs Work But Client PC Cannot Connect to Network Other Problems Problem CauseRestrictions Proper Setup Click on the ‘LAN port’ link on the left Troubleshooting Troubleshooting Glossary Glossary MHz MegaHertz One million cycles per second ROM Read Only Memory Permanent memory PCI Peripheral Component Interconnect aGlossary Glossary Federal Communication Commission Interference Statement FCC / CE InformationFederal Communication Commission Interference Statement Important NotePotential restrictive use FCC RF Radiation Exposure StatementEU Countries intended for use EU Countries Not intended for useWarranty Information General Inquiries Contact Information4030 W. Braker Ln. Suite Austin, Texas Tel Fax