Buffalo Technology WBR2-G54S Time setup, Select Use or Do not use, NTP server name Enter

Page 60

Advanced Settings

New Password - Enter new password. Enter up to eight alphanumeric characters (case sensi- tive)

Confirm Password - Reenter the new password for confi rmation

Time Setup

Time setup

Screen

Time setup - Enter the current

 

 

date and time, and click Set.

 

NTP - Network Time Protocol.

 

Select Use or Do not use.

 

■ Note: If NTP is used, time is

 

set automatically.

 

NTP server name - Enter the

 

NTP server name

 

Update Time - Enter the time

 

interval (in hours) for the time

 

check frequency

 

Time Zone - Select local time

 

zone

 

Click Apply.

60

Image 60
Contents WBR2-G54S Table of Contents Network Settings Table of Contents Introduction Introduction Home Networking SOHO/SMB NetworkingAirStation WBR2-G54S Package Contents System RequirementsProduct Views About the AirStation CD Installation / Setup Setup Preparation Setup OverviewIntroduction Antenna Installation Standard Settings Open the Setup ScreenEnter ISP information DSL ButtonAutomatic IP Assignment by ISP Enter IP Address Manually PPPoE ConnectionCatv Cable Button Line Test Security Simple Security Setup Applications Refer to the on-screen help for Aoss Aoss Additional Aoss Information Advanced Settings LAN SettingsWireless Settings Wireless Function Enable orAdvanced Settings Wireless LAN Security Advanced Settings Characteristics Advanced Settings LAN Port Dhcp Server Advanced Settings Manual IP MAC Address Assignment Settings Wireless MAC Filter Wireless PC’s ConnectionRegister for Allowable PC’s MAC Address Wireless Bridge WDS Advanced Settings WAN Settings Wired WAN PerformanceWAN Port Connection Type Select from MTU Maximum Transmit MRU Maximum ReceiveWAN Network Advanced Settings Network Settings Routing SetupAdd Routing Table Entry Enable or Disable . Address Address TranslationIP Masquerade When Display/Delete NAT Table Add NAT Table Advanced Settings Packet Filter Log Output Select Output toBasic Filter Setting IP Filter Setting MAC Filter Click Enter MAC Lter to enter MAC address Click Apply when settings are complete Intrusion Detector DETECTOR@AIRSTATIONPage UPnP Management System InformationAdmin Name Password Time setup Select Use or Do not useNTP server name Enter Wired WAN Wired LAN Wireless LAN Packet Traffic InformationClient Monitor IP Address and MediumPing Test Log Information Display log info SelectLog information Displays Syslog Transfer Log Information LevelLog Information Select Save/Restore Settings Save current settings ClickRestored saved settings Reboot/Reload Defaults Click Restart to rebootAirStation Firmware Update Com/wirelessFirmware file name Aoss Client Table DisplaysAoss Function Click Enable Manually specify the encrypTemperature & Humidity Power CharacteristicsSpecifications Additional InformationNetworking Characteristics Radio CharacteristicsRegulatory Information Host Operating SystemOpen Office Environment Semi-Open Office Environment 2412 Troubleshooting Common ProblemsLED Activity B Diag LED ActivityChanging Client TCP/IP Settings in Windows Table B.1.1 Diag LED Activity TableLEDs Work But Client PC Cannot Connect to Network Other Problems Problem CauseRestrictions Proper Setup Click on the ‘LAN port’ link on the left Troubleshooting Troubleshooting Glossary Glossary MHz MegaHertz One million cycles per second PCI Peripheral Component Interconnect a ROM Read Only Memory Permanent memoryGlossary Glossary FCC / CE Information Federal Communication Commission Interference StatementImportant Note Federal Communication Commission Interference StatementFCC RF Radiation Exposure Statement EU Countries intended for useEU Countries Not intended for use Potential restrictive useWarranty Information Contact Information General Inquiries4030 W. Braker Ln. Suite Austin, Texas Tel Fax